Abstract:Frequency selective surface (FSS) has extensively been investigated over the past decades. The most famous applications of FSS are used for antennas radome and controlling radar cross section (RCS). FSS radome could reflect the signal out of the band so that the RCS could be reduced by shaping. However, with the development of radar detection technology, the scattering out of the band becomes non-negligible. In order to improve the problem, the FSS rasorber was proposed. It is the combination of the absorber and the radome. In this paper, a wideband transmission FSS rasorber is designed, acting as a stealthy radome to reduce the scattering out of band of the antenna system. The rasorber consists of an absorption layer (LayerA) and a transmission layer (LayerT). The LayerA, which use a resistor-loaded in Jerusalem cross element with non-touching centre, provides stable losses out of band and minimizes losses in the band. The LayerT use as the ground plane of an absorber based on the absorption layer within the total reflection band and providing a transmission window in the band. In order to obtain a wideband transmission, two series chokes are inserted in each leg in the LayerA and the LayerT adopts a second-order resonator. Moreover, the elements are packed densely owing to a skewed grid in the LayerA and the miniaturized non-resonant element in the LayerT. Superdense arrays cause a more stable performance of the rasorber, especially the delay of grating lobes onset. The composite structure is thoroughly analyzed by means of the full-wave numerical simulation. The simulation shows that the -1 dB transmission window is 5.7 ~ 6.7 GHz, and the -10dB reflection band is 2.2 ~ 5.1 GHz. The design would be widely used in broadband antenna system.

Design of Frequency-Selective Surfaces Radome for a Planar Slotted Waveguide Antenna

A Design for FSS on Curved Band-Pass Radome

Filtenna-Filtenna Design for Broadband and High-Selectivity Frequency Selective Surface

A Frequency Selective Surface Radome Using a Coupled Resonator Filter

An FSS-Integrated Low-RCS Radome Design

A Novel Angularly Stable Wide Passband Frequency Selective Surface

A High-Gain, Low Rcs And Dual-Frequency Microstrip Antenna Using Frequency Selective Surface

Broadband low radar cross section frequency selective surface radome based on phase cancellation and spatial filtering

Design of an Invisible Radome by Frequency Selective Surfaces Loaded with Lumped Resistors

EM Design and Analysis of Frequency Selective Surface Based on Substrate-Integrated Waveguide Technology for Airborne Radome Application

Design of Dual-Band Composite Radome Wall With High Angular Stability Using Frequency Selective Surface

Status and Development of Frequency Selective Surface Radome

Design of a Wideband Absorption Frequency Selective Rasorber Based on Double Lossy Layers

Design of Frequency Selective Surface Structure With High Angular Stability for Radome Application

A Wideband Transmission Frequency Selective Surface Rasorber

Design and Simulation of a Miniature Thick-Screen Frequency Selective Surface Radome

Design of FSS Based Radome Wall for Airborne Radar Application

A planar stealthy antenna radome using absorptive frequency selective surface

A Novel Frequency Selective Surface for the RCS Reduction of Antenna Array

Design of a hybrid A-sandwich radome using a strongly coupled frequency selective surface element

Design and simulation of energy selective radome integrated with monopole antenna