Abstract:Frequency selective surface (FSS) has extensively been investigated over the past decades. The most famous applications of FSS are used for antennas radome and controlling radar cross section (RCS). FSS radome could reflect the signal out of the band so that the RCS could be reduced by shaping. However, with the development of radar detection technology, the scattering out of the band becomes non-negligible. In order to improve the problem, the FSS rasorber was proposed. It is the combination of the absorber and the radome. In this paper, a wideband transmission FSS rasorber is designed, acting as a stealthy radome to reduce the scattering out of band of the antenna system. The rasorber consists of an absorption layer (LayerA) and a transmission layer (LayerT). The LayerA, which use a resistor-loaded in Jerusalem cross element with non-touching centre, provides stable losses out of band and minimizes losses in the band. The LayerT use as the ground plane of an absorber based on the absorption layer within the total reflection band and providing a transmission window in the band. In order to obtain a wideband transmission, two series chokes are inserted in each leg in the LayerA and the LayerT adopts a second-order resonator. Moreover, the elements are packed densely owing to a skewed grid in the LayerA and the miniaturized non-resonant element in the LayerT. Superdense arrays cause a more stable performance of the rasorber, especially the delay of grating lobes onset. The composite structure is thoroughly analyzed by means of the full-wave numerical simulation. The simulation shows that the -1 dB transmission window is 5.7 ~ 6.7 GHz, and the -10dB reflection band is 2.2 ~ 5.1 GHz. The design would be widely used in broadband antenna system.

Design of a hybrid A-sandwich radome using a strongly coupled frequency selective surface element

EM Design and Analysis of Frequency Selective Surface Based on Substrate-Integrated Waveguide Technology for Airborne Radome Application

Design of FSS Based Radome Wall for Airborne Radar Application

Mechanical and electromagnetic behavior of fabricated hybrid composite sandwich radome with a new optimized frequency-selective surface

Dual-Band A-Sandwich Radome Design for Airborne Applications

Design of an Invisible Radome by Frequency Selective Surfaces Loaded with Lumped Resistors

Design of Frequency-Selective Surfaces Radome for a Planar Slotted Waveguide Antenna

Design, Modelling, and Manufacturing of Sandwich Radome Structure with Out-of-band Absorption and In-Band Transmission Performances

Design and Characterization for Dual-Band and Multi-Band A-sandwich Composite Radome Walls

Design of Dual-Band Composite Radome Wall With High Angular Stability Using Frequency Selective Surface

Intelligent Radome Design With Multilayer Composites to Realize Asymmetric Transmission of Electromagnetic Waves and Energy Isolation

A Wideband Transmission Frequency Selective Surface Rasorber

An FSS-Integrated Low-RCS Radome Design

Filtenna-Filtenna Design for Broadband and High-Selectivity Frequency Selective Surface

Electrical Performance of a Dual-Band Composite Radome

A Novel Angularly Stable Wide Passband Frequency Selective Surface

A planar stealthy antenna radome using absorptive frequency selective surface

A Novel Miniaturized Multiband Strong Coupled-FSS Structure Insensitive to Almost All Angles and All Polarizations

A Novel FSS Structure with Great Insensitivity to Incident Angles for High Performance Millimeter Wave Communication Radome

A Novel Almost All-Angle-insensitive FSS Structure for High-Performance Radome

Broadband low-scattering and high-efficiency transmission radome by combining phase gradient metasurface and FSS