Abstract:Cu/MgO-Al2O3 (Mg/Al atomic ratio=1/1, 3/1, 4/1), Cu/MgO and Cu/Al2O3 catalysts with high Cu dispersions were prepared by an impregnation method using ethanol as solvent instead of water. Compared to water, ethanol as solvent was favorable not only for obtaining the high dispersions of the Cu clusters on the basic oxide supports, but also for retaining the basicity and structures of the supports during the catalyst preparation. The density of the basic sites for the dispersed Cu catalysts increased with increasing the MgO contents in the basic supports. These catalysts catalyzed glycerol hydrogenolysis to propylene glycol with a high selectivity (>90%), and showed slight deactivation in dioxane at 200 degrees C and 6.0 MPa H-2. Their reaction rates normalized by per exposed Cu atom increased with increasing the ratios of the basic sites to Cu atoms on the catalyst surfaces. The intrinsic hydrogenolysis activity of the Cu atoms were probed by N2O chemisorption-H-2 temperature programmed reduction, which did not change essentially with the Cu loadings (2-6 wt%) and the Mg/Al atomic ratios of the MgO-Al2O3 supports. Meanwhile, the basic sites alone on the supports were inactive for the glycerol conversion. Taken together, we propose a synergetic effect that the basic sites at the interfaces between the Cu sites and the supports assist the cleavage of alpha-C-H bonds of glycerol on the Cu surfaces leading to the faster dehydrogenation of glycerol to glyceraldehyde, a kinetically-relevant step in glycerol hydrogenolysis to propylene glycol. These active basic sites appear to be the Bronsted OH- sites, i.e. the hydroxyl groups bonded to the surface Mg2+ cations on MgO-Al2O3. The understanding on such synergy between the basic sites and Cu sites in glycerol hydrogenolysis provides a basis for the rational design of superior hydrogenolysis catalysts and selective removal of oxygen from biomass-derived feedstocks.

Copper zinc aluminate synthesized by sol‐gel method with polyacrylic acid as catalysts for glycerol hydrogenolysis

Super solid-base supported Cu catalysts for hydrogenolysis of glycerol to 1,2-propanediol

Hydrogenolysis of glycerol over homogenously dispersed copper on solid base catalysts

Selective Hydrogenolysis of Glycerol to Propylene Glycol on Hydroxycarbonate-Derived Cu-Zno-Al2o3 Catalysts

In Situ Growth of Tungsten Oxide on Alumina to Boost the Catalytic Performance of Platinum for Glycerol Hydrogenolysis

Glycerol Valorization over ZrO2-Supported Copper Nanoparticles Catalysts Prepared by Chemical Reduction Method

Platinum–copper single atom alloy catalysts with high performance towards glycerol hydrogenolysis

Nickel aluminate spinel-derived catalysts for aqueous-phase hydrogenolysis of glycerol with in-situ hydrogen production: Effect of molybdenum doping

Research on Hydrogenolysis of Glycerol to 1, 2-Propylene Glycol by Using Supported Raney-Cu/Al 2 O 3

Hydrogenolysis of Glycerol over Cu0.4/Zn5.6−xMgxAl2O8.6 Catalysts: the Role of Basicity and Hydrogen Spillover

Selective Hydrogenolysis of Glycerol to Propylene Glycol on MgO-Al2O3Dispersed Cu Catalysts

Pure silica Beta zeolite supported copper species for efficient hydrogenolysis of glycerol to 1,2-propanediol

Multiwall Carbon Nanotube-Pillared Layered Cu-0.4/Mg5.6al2o8.6: An Efficient Catalyst For Hydrogenolysis Of Glycerol

Hydrogenolysis of Glycerol on Bimetallic Pd-Cu/solid-base Catalysts Prepared Via Layered Double Hydroxides Precursors

Ni Doped Cu-ZnO Catalyst for Glycerol Hydrogenolysis

Application of Co-Al Catalysts in Hydrogenation of Glycidol to 1,3-Propanediol

Efficient Catalytic Hydrogenolysis of Glycerol Using Formic Acid As Hydrogen Source

Preparation and Characterization of Copper-based Hydrogenation Catalysts Used for Neopentyl Glycol Synthesis

Oxidation of glycerol to dihydroxyacetone over highly stable Au catalysts supported on mineral-derived CuO-ZnO mixed oxide

Selective hydrogenolysis of glycerol to propylene glycol on Cu–ZnO catalysts

Plant-mediated Biosynthesized Au/CuO Catalysts for Efficient Glycerol Oxidation to 1,3-Dihydroxyacetone: Effect of Biomass Component on Catalytic Activity