Abstract:Cu/MgO-Al2O3 (Mg/Al atomic ratio=1/1, 3/1, 4/1), Cu/MgO and Cu/Al2O3 catalysts with high Cu dispersions were prepared by an impregnation method using ethanol as solvent instead of water. Compared to water, ethanol as solvent was favorable not only for obtaining the high dispersions of the Cu clusters on the basic oxide supports, but also for retaining the basicity and structures of the supports during the catalyst preparation. The density of the basic sites for the dispersed Cu catalysts increased with increasing the MgO contents in the basic supports. These catalysts catalyzed glycerol hydrogenolysis to propylene glycol with a high selectivity (>90%), and showed slight deactivation in dioxane at 200 degrees C and 6.0 MPa H-2. Their reaction rates normalized by per exposed Cu atom increased with increasing the ratios of the basic sites to Cu atoms on the catalyst surfaces. The intrinsic hydrogenolysis activity of the Cu atoms were probed by N2O chemisorption-H-2 temperature programmed reduction, which did not change essentially with the Cu loadings (2-6 wt%) and the Mg/Al atomic ratios of the MgO-Al2O3 supports. Meanwhile, the basic sites alone on the supports were inactive for the glycerol conversion. Taken together, we propose a synergetic effect that the basic sites at the interfaces between the Cu sites and the supports assist the cleavage of alpha-C-H bonds of glycerol on the Cu surfaces leading to the faster dehydrogenation of glycerol to glyceraldehyde, a kinetically-relevant step in glycerol hydrogenolysis to propylene glycol. These active basic sites appear to be the Bronsted OH- sites, i.e. the hydroxyl groups bonded to the surface Mg2+ cations on MgO-Al2O3. The understanding on such synergy between the basic sites and Cu sites in glycerol hydrogenolysis provides a basis for the rational design of superior hydrogenolysis catalysts and selective removal of oxygen from biomass-derived feedstocks.

Hydrogenolysis of Glycerol over Cu0.4/Zn5.6−xMgxAl2O8.6 Catalysts: the Role of Basicity and Hydrogen Spillover

Selective Hydrogenolysis of Glycerol to Propylene Glycol on MgO-Al2O3 Dispersed Cu Catalysts

Kinetics of Hydrogenolysis of Glycerol to Propylene Glycol over Cu-Zno-Al2o3 Catalysts

Hydrogenolysis of glycerol over homogenously dispersed copper on solid base catalysts

Selective Hydrogenolysis of Glycerol to Propylene Glycol on Hydroxycarbonate-Derived Cu-Zno-Al2o3 Catalysts

Hydrogenolysis of Glycerol over Cu-substituted Hydrocalumite Mediated Catalysts

Catalytic in Situ Hydrogenation of Fatty Acids into Fatty Alcohols over Cu-Based Catalysts with Methanol in Hydrothermal Media

Super solid-base supported Cu catalysts for hydrogenolysis of glycerol to 1,2-propanediol

Selective Hydrogenolysis of Glycerol to Propylene Glycol on Cu–ZnO Composite Catalysts: Structural Requirements and Reaction Mechanism

Hydrogenolysis of Glycerol on Bimetallic Pd-Cu/solid-base Catalysts Prepared Via Layered Double Hydroxides Precursors

Selective hydrogenolysis of glycerol to propylene glycol on Cu–ZnO catalysts

Role of Initial Water Content in Glycerol Hydrogenolysis to 1,2-Propanediol over Cu–ZnO Catalyst

Hydrogenolysis of glycerol to 1,2-propanediol over Cu-based catalysts: A short review

Hydrogen-free Synthesis of 1,2-Propanediol from Glycerol over Cu–Mg–Al Catalysts

CuZnAlOOH catalysts with Cu0/Cu+ constructed by two-step hydrolysis for ethanol production from syngas

Multiwall Carbon Nanotube-Pillared Layered Cu-0.4/Mg5.6al2o8.6: An Efficient Catalyst For Hydrogenolysis Of Glycerol

Biodiesel Derived Glycerol Hydrogenolysis to 1,2-Propanediol on Cu/Mgo Catalysts

Selective Hydrogenolysis of Glycerol to Propylene Glycol on Supported Pd Catalysts: Promoting Effects of Zno and Mechanistic Assessment of Active Pdzn Alloy Surfaces

Hydrogenolysis of glycerol over Pt/C catalyst in combination with alkali metal hydroxides

Effect of ZnO incorporation on Cu–Ni/Al 2 O 3 catalyst for glycerol hydrogenolysis in the absence of added hydrogen

Selective hydrogenolysis of raw glycerol to 1,2-propanediol over Cu–ZnO catalysts in fixed-bed reactor