Abstract:Cu/MgO-Al2O3 (Mg/Al atomic ratio=1/1, 3/1, 4/1), Cu/MgO and Cu/Al2O3 catalysts with high Cu dispersions were prepared by an impregnation method using ethanol as solvent instead of water. Compared to water, ethanol as solvent was favorable not only for obtaining the high dispersions of the Cu clusters on the basic oxide supports, but also for retaining the basicity and structures of the supports during the catalyst preparation. The density of the basic sites for the dispersed Cu catalysts increased with increasing the MgO contents in the basic supports. These catalysts catalyzed glycerol hydrogenolysis to propylene glycol with a high selectivity (>90%), and showed slight deactivation in dioxane at 200 degrees C and 6.0 MPa H-2. Their reaction rates normalized by per exposed Cu atom increased with increasing the ratios of the basic sites to Cu atoms on the catalyst surfaces. The intrinsic hydrogenolysis activity of the Cu atoms were probed by N2O chemisorption-H-2 temperature programmed reduction, which did not change essentially with the Cu loadings (2-6 wt%) and the Mg/Al atomic ratios of the MgO-Al2O3 supports. Meanwhile, the basic sites alone on the supports were inactive for the glycerol conversion. Taken together, we propose a synergetic effect that the basic sites at the interfaces between the Cu sites and the supports assist the cleavage of alpha-C-H bonds of glycerol on the Cu surfaces leading to the faster dehydrogenation of glycerol to glyceraldehyde, a kinetically-relevant step in glycerol hydrogenolysis to propylene glycol. These active basic sites appear to be the Bronsted OH- sites, i.e. the hydroxyl groups bonded to the surface Mg2+ cations on MgO-Al2O3. The understanding on such synergy between the basic sites and Cu sites in glycerol hydrogenolysis provides a basis for the rational design of superior hydrogenolysis catalysts and selective removal of oxygen from biomass-derived feedstocks.

Super solid-base supported Cu catalysts for hydrogenolysis of glycerol to 1,2-propanediol

Hydrogenolysis of glycerol over homogenously dispersed copper on solid base catalysts

Selective Hydrogenolysis of Glycerol to Propylene Glycol on MgO-Al2O3Dispersed Cu Catalysts

Hydrogenolysis of Glycerol over Cu0.4/Zn5.6−xMgxAl2O8.6 Catalysts: the Role of Basicity and Hydrogen Spillover

Hydrogenolysis of Glycerol on Bimetallic Pd-Cu/solid-base Catalysts Prepared Via Layered Double Hydroxides Precursors

Hydrogenolysis of Glycerol over Cu-substituted Hydrocalumite Mediated Catalysts

Pure silica Beta zeolite supported copper species for efficient hydrogenolysis of glycerol to 1,2-propanediol

Hydrogenolysis of glycerol to 1,2-propanediol over Cu-based catalysts: A short review

Selective Hydrogenolysis of Glycerol to Propylene Glycol on Hydroxycarbonate-Derived Cu-Zno-Al2o3 Catalysts

Research on Hydrogenolysis of Glycerol to 1, 2-Propylene Glycol by Using Supported Raney-Cu/Al 2 O 3

Biodiesel Derived Glycerol Hydrogenolysis to 1,2-Propanediol on Cu/Mgo Catalysts

Preparation of Highly Dispersed Cu Catalysts from Hydrotalcite Precursor for the Dehydrogenation of 1,4-Butanediol

Effect of Bimetallic Co-Cu/Dolomite Catalyst on Glycerol Conversion to 1,2-Propanediol

Research progress of catalyst in catalytic hydrogenolysis of glycerol to 1,2-propanediol

Easily Recycled CuMgFe Catalysts Derived from Layered Double Hydroxides for Hydrogenolysis of Glycerol

Selective Hydrogenolysis of Glycerol to 1,2-Propanediol Catalyzed by Supported Bimetallic PdCu-KF/γ-Al2O3

Multiwall Carbon Nanotube-Pillared Layered Cu-0.4/Mg5.6al2o8.6: An Efficient Catalyst For Hydrogenolysis Of Glycerol

Platinum–copper single atom alloy catalysts with high performance towards glycerol hydrogenolysis

Ni Doped Cu-ZnO Catalyst for Glycerol Hydrogenolysis

Pt/Solid-Base: A Predominant Catalyst for Glycerol Hydrogenolysis in a Base-Free Aqueous Solution

Selective hydrogenolysis of glycerol to propylene glycol on Cu–ZnO catalysts