Abstract:Cu/MgO-Al2O3 (Mg/Al atomic ratio=1/1, 3/1, 4/1), Cu/MgO and Cu/Al2O3 catalysts with high Cu dispersions were prepared by an impregnation method using ethanol as solvent instead of water. Compared to water, ethanol as solvent was favorable not only for obtaining the high dispersions of the Cu clusters on the basic oxide supports, but also for retaining the basicity and structures of the supports during the catalyst preparation. The density of the basic sites for the dispersed Cu catalysts increased with increasing the MgO contents in the basic supports. These catalysts catalyzed glycerol hydrogenolysis to propylene glycol with a high selectivity (>90%), and showed slight deactivation in dioxane at 200 degrees C and 6.0 MPa H-2. Their reaction rates normalized by per exposed Cu atom increased with increasing the ratios of the basic sites to Cu atoms on the catalyst surfaces. The intrinsic hydrogenolysis activity of the Cu atoms were probed by N2O chemisorption-H-2 temperature programmed reduction, which did not change essentially with the Cu loadings (2-6 wt%) and the Mg/Al atomic ratios of the MgO-Al2O3 supports. Meanwhile, the basic sites alone on the supports were inactive for the glycerol conversion. Taken together, we propose a synergetic effect that the basic sites at the interfaces between the Cu sites and the supports assist the cleavage of alpha-C-H bonds of glycerol on the Cu surfaces leading to the faster dehydrogenation of glycerol to glyceraldehyde, a kinetically-relevant step in glycerol hydrogenolysis to propylene glycol. These active basic sites appear to be the Bronsted OH- sites, i.e. the hydroxyl groups bonded to the surface Mg2+ cations on MgO-Al2O3. The understanding on such synergy between the basic sites and Cu sites in glycerol hydrogenolysis provides a basis for the rational design of superior hydrogenolysis catalysts and selective removal of oxygen from biomass-derived feedstocks.

Ni Doped Cu-ZnO Catalyst for Glycerol Hydrogenolysis

Sol-Gel Preparation, Characterization and Hydrogenation Property of Silica Supported Ni Catalyst

Efficient and Stable Cu-Ni/ZrO2 Catalysts for in Situ Hydrogenation and Deoxygenation of Oleic Acid into Heptadecane Using Methanol As a Hydrogen Donor

Reforming and Hydrogenolysis of Glycerol over Ni/ZnO Catalysts Prepared by Different Methods

Selective hydrogenolysis of raw glycerol to 1,2-propanediol over Cu–ZnO catalysts in fixed-bed reactor

Biodiesel Derived Glycerol Hydrogenolysis to 1,2-Propanediol on Cu/Mgo Catalysts

Selective Hydrogenolysis of Glycerol to Propylene Glycol on Hydroxycarbonate-Derived Cu-Zno-Al2o3 Catalysts

Effect of Phosphine Doping and the Surface Metal State of Ni on the Catalytic Performance of Ni/Al2O3 Catalyst

Super solid-base supported Cu catalysts for hydrogenolysis of glycerol to 1,2-propanediol

Synergistic effect of Ni-NbW with binuclear acidity for the hydrogenolysis of Glycerol

Hydrogenolysis of Glycerol on Bimetallic Pd-Cu/solid-base Catalysts Prepared Via Layered Double Hydroxides Precursors

Efficient Hydrogenation of Dimethyl Oxalate to Ethylene Glycol Via Nickel Stabilized Copper Catalysts

Hydrogenolysis of glycerol to 1,2-propanediol over Cu-based catalysts: A short review

Physically Mixed ZnO and Skeletal NiMo for One-Pot Reforming-Hydrogenolysis of Glycerol to 1,2-Propanediol

Significant effect of In doping on Ni/C catalyst for hydrogenation of dimethyl oxalate to ethanol: Synergistic effect of InNi 3 alloy, surface oxygen, and defect sites

Ni-Modified Ag/SiO2 Catalysts for Selective Hydrogenation of Dimethyl Oxalate to Methyl Glycolate

Hydrogenolysis of Glycerol over Cu0.4/Zn5.6−xMgxAl2O8.6 Catalysts: the Role of Basicity and Hydrogen Spillover

Research on Hydrogenolysis of Glycerol to 1, 2-Propylene Glycol by Using Supported Raney-Cu/Al 2 O 3

Selective Hydrogenolysis of Glycerol to Propylene Glycol on MgO-Al2O3Dispersed Cu Catalysts

Effect of Bimetallic Co-Cu/Dolomite Catalyst on Glycerol Conversion to 1,2-Propanediol

Ni/NaX: A Bifunctional Efficient Catalyst for Selective Hydrogenolysis of Glycerol