Abstract:Abrasive water jet (AWJ) is a type of cold processing technology, and there are many factors affecting its machining effect. In this paper, a coupled Finite Element Methods-Smoothed Particle Hydrodynamics (FEM-SPH) numerical model was established to investigate the key influencing factors of AWJ machining ductile materials. The abrasive particles in the model were shaped as irregular polyhedrons, and the material properties of the abrasive particles as well as the influence mechanism of the fluid–structure interaction between the abrasive particles and the water were considered. The relative error range of experimental measured results and simulation predicted results is 22.77%–36.55%. Then, the effects of content and distribution of abrasive particles, the jet working pressure P, the traverse rate of nozzle V t r a v and the impingement angle α were systematically and quantitatively evaluated through two-way verification of experiments and simulations. It was found that: (i) Effects of stand-off distance (SOD) on the kerf profile and the quality of kerf surface was essentially determined by the content and distribution of abrasive particles. As the increase of SOD, the jet divergence gradually increases, and the kerf profile gradually changes from “U-shaped” to “V-shaped”. (ii) Experiments and simulations demonstrate that the P has a linear increasing relationship with the maximum depth h of kerf profile, and the V t r a v has a linear decreasing relationship with the maximum depth h, while it has a linear increasing relationship with the jet trailing angle β , which was independent of the ductile material type. (iii) The combined effect of V t r a v and α affects geometric parameters and surface quality of the kerf profile, under the same P, the depth of the cut surface obtained by backward cutting is only 72.1% of that of the forward cutting, while the quality of the cut surface of former one is higher than the latter one.

A Novel Technique for Dressing Fixed Abrasive Lapping Pad with Abrasive Water Jet

Process Parameter Modeling and Optimization of Abrasive Water Jet Dressing Fixed-Abrasive Pad Based on Box–Behnken Design

An Exploration of the Influence of Abrasive Water Jet Pressure on the Friction Signal Characteristics of Fixed Abrasive Lapping Quartz Glass Based on HHT

Numerical Research on Kerf Characteristics of Abrasive Waterjet Machining Based on the SPH-DEM-FEM Approach

Experimental and simulation study on the influence factors of abrasive water jet machining ductile materials

Kinematics and Trajectory Analysis of the Fixed Abrasive Lapping Process in Machining of Interdigitated Micro-Channels on Bipolar Plates

Analysis and optimization of abrasive waterjet dressing parameters for surface texturing of diamond grinding wheels

Surface removal of ductile metal using cyclic low-frequency impact of a discrete particle-less waterjet

Research on Multiphase Flow and Nozzle Wear in a High-Pressure Abrasive Water Jet Cutting Head

Parameter Optimization and Effect Analysis of Low-Pressure Abrasive Water Jet (LPAWJ) for Paint Removal of Remanufacturing Cleaning

Simulation and Optimization of the Nozzle Section Geometry for a Suspension Abrasive Water Jet

Nozzle Wear in Abrasive Water Jet Based on Numerical Simulation

Mechanism of C /SiC hole making with high shape precision using abrasive waterjet based on response surface method

Research on the multilevel energy decrement strategy for abrasive waterjet peening Ti6Al4V

The Influence of Impact Angle on Material Removal in Fluid Jet Polishing

Friction and wear characteristics of agglomerated diamond abrasives and lapping performance of fixed agglomerated diamond pads

Novel cavitation fluid jet polishing process based on negative pressure effects

Theoretical and Experimental Investigation on a Novel Cavitation-Assisted Abrasive Flow Polishing Method

Research Progress in Abrasive Water Jet Processing Technology

Hole characteristics and surface damage formation mechanisms of C /SiC composites machined by abrasive waterjet