Abstract:This paper presents an analysis on pile shaft capacity of an instrumented displacement pile subjected to cyclic axial loading. This pile developed by Imperial College was installed at the Grenoble Calibration Chamber in a medium dense siliceous sand sample reconstituted by air pluviation technique. Shaft shear and normal stresses at pile interface along the pile were recorded. Soil stress sensors were deployed at different levels in the sand mass around the pile to monitor the vertical, radial and circumferential stresses. Several one-way low cyclic loading tests, employing a range of cyclic amplitudes, and several large twoway cyclic loading tests were carried out. Uplift tensile loading tests were performed before and after each series of cyclic loading. In addition, measurements of the local stress paths allowed an analysis of how interface local shear capacity was affected by cyclic loading. The results indicated the degradation of skin friction depends on the cyclic amplitude respect to the total static capacity of the pile. The pile shaft capacity increased slightly after low amplitude cycling, and decreased considerably after large two-way cycling or high one-way loading, corresponding to either enhancements or reductions in local normal effective stresses at failure. The interpretation of the local stress paths is in agreement with the pile uplift capacity trends established from post cycling load tests to failure.

Experimental Technique for Impact Testing of Concrete Piles

Model Tests on Elevated Piles Subjected to Lateral Static and Impact Loading

Experimental Studies on Seismic Behavior of Steel Pile-to-Pile-Cap Connections

Field Trials on Monotonic Behaviour of a Driven Pile at an Offshore Wind Farm in China

Field Tests of Offshore Driven Piles Subjected to Lateral Monotonic and Cyclic Loads in Soft Clay

Soil-pile interaction on an instrumented pile under cyclic axial loads in sand

Model Test Study of Bearing Behavior of Small Prefabricated Piles in Soft Soil Area

Model Tests on the Bearing Capacity of Precast Open-Ended Micro Pipe Piles in Soft Soil

Test Research on the Behavior of Composite Foundations Incorporating Rigid and Flexible Piles

Experimental Studies on Precast Prestressed Concrete Pile to Cip Concrete Pile-Cap Connections

Experimental Study on Behavior of Composite Foundation with Rigid-Flexible Piles

A New and Openly Accessible Database of Tests on Piles Driven in Sands

A Destructive Field Study on the Behavior of Pile under Ten

A Model Test on the Behavior of A Static Drill Rooted Nodular Pile under Compression

Hammer'S Impact Force on Pile and Pile'S Penetration

Testing and Modeling the Behavior of Pre-Bored Grouting Planted Piles under Compression and Tension

A test on base bearing capacity of static drill rooted nodular pile

Centrifugal Model Tests on Working Behavior of Composite Foundation Reinforced by Rigid Piles with Caps Under Embankment

Field Behavior of Driven Prestressed High-Strength Concrete Piles in Sandy Soils

Laboratory tests on the frictional capacity of core pile - cemented soil interface