Abstract:CFMPs (cement and fly ash mixing piles) are used to reinforce fly ash foundation to solve the problem of a large amount of fly ash accumulation in coastal areas. CFMP-fly ash composite foundation is used as the foundation of coastal and coastal engineering. Through the indoor model test, the bearing characteristics and load transfer mechanism of CFMP-fly ash composite foundation under wave load were investigated. The results show that with the increase of wave load, the horizontal resistance of the fly ash stratum increases gradually, the soil resistance moves down, and the level of resistance shows nonlinear characteristics. The pile bending moment, pile displacement, and horizontal resistance of the CFMP composite foundation are concentrated in the upper pile and fly ash stratum, which can improve the ability of the composite foundation to resist horizontal load by improving the physical and mechanical properties of the upper fly ash stratum. Through the calculation of the load–displacement curve, it is found that the measured displacement value is closer to that obtained using the p – y curve method (a method for solving nonlinear lateral resistance of piles). The hysteretic curve area of cyclic loading decreases with the increase of cyclic number. The accumulation of elastoplastic deformation of pile shows that the properties of fly ash gradually change to elastic stage, cyclic loading can reduce the horizontal deformation modulus of composite foundation CFMP caused pile—fly ash system of weakening, in peak load reaches level under the critical state displacement curve showed a trend of the rapid growth of nonlinear, cyclic cumulative failure occurs, and the cyclic load limit state is reached, which affects the service performance of the whole structure.

Hammer'S Impact Force on Pile and Pile'S Penetration

MPM Modeling of Pile Installation in Sand: Contact Improvement and Quantitative Analysis

STUDY ON SINGLE RIGID PILE GROUND IMPROVEMENT MODEL UNDER EMBANKMENT

Model Tests on Elevated Piles Subjected to Lateral Static and Impact Loading

Model Tests on the Bearing Capacity of Precast Open-Ended Micro Pipe Piles in Soft Soil

An Approach to Analyzing the Transverse Vibration of a Pile during Pile Driving

Study on pile drivability with a simplified method

Experimental Technique for Impact Testing of Concrete Piles

Influence of different combinations of impact mass and velocity with identical kinetic energy or momentum on the impact response of RC piles

A Model Test on the Behavior of A Static Drill Rooted Nodular Pile under Compression

Influence of the Penetration of Adjacent X-section Cast-in-place Concrete (XCC) Pile on the Existing XCC Pile in Sand

Multiple Impact Phenomenon in Impact Hammer Testing: Theoretical Analysis and Numerical Simulation

On Vertical Dynamic Stability and Cross‐section Optimization of Closed‐ended Hollow Pile by Considering Soil Compaction Effects

Dynamic Response of Cement–Fly Ash Mixed Pile Composite Foundation Under Wave Load

Numerical Simulation and Factor Analysis of Jacked Pile Compacting Effects

Influence Of Excavation Unloading On Vertical Bearing Behavior Of Existing Pile Groups

Effect of Cyclic Jacking on Sand-Pile Interface Shear Behaviour

Model Test on Load Transfer Mechanism of a Static Drill Rooted Nodular Pile

Numerical analysis on the performance of a cushioned foundation with a mixture of both rigid and flexible piles

Analysis of stress and failure mechanism on composite foundation improved by rigid piles under flexible foundation considering damage of piles

Impact Model Tests and Simplified Analysis for Flexible Pile-Supported Protective Structures Withstanding Vessel Collisions