Abstract:This paper presents a novel design for uplift piles incorporating a composite-anchor system. The composite-anchor system consists of steel strands, a non-expansion grouting body, and a high-strength steel pile. The aim of this design is to enhance the mechanical performance, durability, and economic efficiency of uplift piles. To evaluate the performance of the new pile, three sets of full-scale load tests were conducted, focusing on their in situ capacity, deformation, and stress characteristics. Despite a significantly lower reinforcement ratio of 0.75% compared to conventional piles with a ratio of 3.84%, the new uplift piles exhibit an exceptional uplift bearing performance. The utilization of the lateral friction resistance of the lower pile body is significantly improved, leading to enhanced load distribution and stress transfer mechanisms. Furthermore, a numerical model was developed and validated against the experimental results, demonstrating its reliability in simulating the bearing characteristics of the new uplift piles. The multi-interface design of the composite-anchor system ensures the efficient transmission of internal forces induced by external uplift loads, resulting in an improved stress state within the pile body. Moreover, the multi-layer structure of the composite main bar enhances the durability of the uplift piles. In comparison to conventional piles, the new uplift pile design offers substantial advantages, including an 80% reduction in reinforcement ratio, a 65% reduction in reinforcement cage welding, a cost reduction of approximately 30%, and a shortened construction time by around 20%. These findings highlight the potential of the new composite-anchor-pile design to revolutionize the field of uplift pile applications, offering improved efficiency and effectiveness.

Model Tests on Granular Pile Anchor and Helical Anchor: A Comparative Study

The Installation Behavior and Capacity of Piggy-Backed Anchors for Offshore Wind Turbine

Centrifuge Modelling of Suction Anchor Subjected to Inclined Load in Soft Clay

Comparative Analysis of Helical Piles and Granular Anchor Piles for Foundation Stabilization in Expansive Soil: A 3D Numerical Study

Performance of laterally loaded H-piles in sand

Bearing Performance of a Novel Caisson-Plate Gravity Anchor

Centrifuge Model Tests on Laterally Loaded Piles in Sand

Dynamic Installation Behaviors of A New Hybrid Plate Anchor in Layered Marine Clay

Effect of load inclination on the uplift capacity of the granular anchor pile foundation in cohesive soil

Experimental Studies on Seismic Behavior of Steel Pile-to-Pile-Cap Connections

MPM Modeling of Pile Installation in Sand: Contact Improvement and Quantitative Analysis

Uplift Capacity of Single And Group of Granular Anchor Pile System

Comparative Study Of Anchor Double-Row Piles And Frame Double-Row Piles

Model Test And Numerical Analysis Of Geogrid-Reinforced Pile-Supported Foundation

Development and Mechanical Property Analysis of a Novel Uplift Pile Incorporating Composite Anchors

Installation Disturbance of Helical Anchor in Dense Sand and the Effect on Uplift Capacity Based on Discrete Element Method

Laboratory Model Study on the Pile-Forming Mechanisms and Bearing Deformation Characteristics of CFA Piles

Calculation Method of Uplift Capacity of Pile-Anchor Composite Foundation and Influence of Parameters

Model tests comparing the behavior of pre-bored grouted planted piles and a wished-in-place concrete pile in dense sand

Response of anchor foundations in geogrid reinforced sand under combined loading conditions

Centrifugal Model Tests on Working Behavior of Composite Foundation Reinforced by Rigid Piles with Caps Under Embankment