Abstract:The relationship between von Mises equivalent stress <math>σ¯</math> and equivalent plastic strain <math>ε¯</math> (PEEQ), termed as von Mises stress-strain, plays an important role in numerical simulations for ductile fracture of structural metallic materials with large plastic strain. The standard uniaxial tensile test on cylindrical specimens is the most straightforward method to derive the (<math>σ¯−ε¯</math>) data. However, the distribution of the stress and strain along the necking section of the tensile specimen is no longer uniform in the post-necking process, which induces difficulty in acquiring the (<math>σ¯−ε¯</math>) data. The existing correction methods to identify von Mises stress-strain in the post-necking regime need instantaneous geometry of the notched region and ignore influence of the initial geometry of the specimen, which induces these methods are inconvenient for application and inapplicable for circumferentially notched tensile specimens to determine (<math>σ¯−ε¯</math>) of each individual material zone in a hybrid coupon (e.g. weldment). In the present study, influences of initial geometry of the specimen and plastic hardening property of material on necking process are investigated firstly. It is found that the shrinking behavior of the minimum cross-section of the specimen is determined by the geometric parameter of specimen and plastic hardening exponent of materials. Based on an extensive parametric study a modified power law function to characterize the von Mises stress-strain curve from tensile tests on circumferentially notched specimens without measuring instantaneous geometry of cross-section is proposed.

The influence of the hardening curve of a material on the results of torsion tests of notched specimens

Interpretation of Torsional Shear Results for Nonlinear Stress–strain Relationship

Investigation of Cyclic Deformation Behavior in the Surface Layer of 18cr–8ni Austenitic Stainless Steel Based on Vickers Microhardness Measurement

Multi-scale Deformation Behavior Investigation of 18cr–8ni Austenitic Steel Subjected to Low-Cycle Fatigue Loading

Effects of Notch Geometry on Stress–strain Distribution, Martensite Transformation and Fracture Behavior in Shape Memory Alloy NiTi

Effect of Notch on the High and Low Cycles Fatigue of TC21 Alloy

Extraordinary strain rate softening of metals in torsion

A finite element analysis of evolution of stress–strain and martensite transformation in front of a notch in shape memory alloy NiTi

The Influence of Isothermal Loading-Unloading Cycles on Inelastic Properties of a TiNi-Based Alloy in the B2-Phase State During Bending Deformation

Mesomechanical Aspects of the Strain-Rate Sensitivity of Armco-Iron Pulled in Tension

Effect Of Notch On Strain Rate Concentration Factor Of 304 Stainless Steel Bar

Effect of Notch Root Radius on Stress-Strain Distribution and Martensite Transformation of Shape-Memory Alloy NiTi in Front of Notch

Simplified method to identify full von Mises stress-strain curve of structural metals

Radial Dependences of the Phase Composition, Nanohardness, and Young's Modulus for Ti–2 wt % Fe Alloy after High-Pressure Torsion

Stress–strain curves of metallic materials and post‐necking strain hardening characterization: A review

Effects of notch width and loading rate on the dynamic mode II fracture toughness of Ti-6Al-4V

Influence of the Structure of a VT22I Titanium Alloy on Deformation Mechanisms during the Shape Memory Effect

Effects of tensile prestrain on the notch toughness of low-alloy steel

Study of Microstructure and Mechanical Properties by Torsional Behavior in Axial Closed Die Rolling Forming

Combination of Strength and Plasticity of a Low Alloy Steel after Torsional Prestrain

Bending of Pseudoelastic NiTi Tubes