Abstract:TS1-20 Abstract: A model has recently been proposed to predict the emission rate of semivolatile organic compounds (SVOCs) from polymer materials. The model was based on data collected in an experimental study that measured emissions of di-2-ethylhexyl phthalate (DEHP) from vinyl flooring. The analysis revealed that although emissions of volatile organic compounds (VOCs) are generally subject to “internal” control (the material-phase diffusion coefficient), emissions of the very low volatility SVOCs (such as DEHP) are subject to “external” control (partitioning into the gas phase, the convective mass-transfer coefficient, and adsorption onto interior surfaces). The analysis showed that adsorption to interior surfaces strongly influences the emission rate. This inference is supported by the recent experimental finding that the presence of indoor dust increases the emission rate of DEHP from vinyl flooring in a test chamber. Compared with the 2 simple chamber systems studied, a regular indoor environment has many other types of surface that will adsorb SVOCs to different extents. The emission rate measured in the test chambers may therefore be vastly different from the actual emission rate from the exact same material into a typical indoor environment. The new model provides a convenient means to estimate the true emission rate and evolving gas phase and adsorbed surface concentrations likely to occur in real indoor environments. The missing information is the adsorption isotherm for DEHP on the different types of indoor surfaces. Although very little information is available on adsorption of DEHP and other SVOCs to indoor surfaces, the recent EPA-sponsored Children's Total Exposure to Persistent Pesticides and Other Persistent Organic Pollutants (CTEPP) study has measured concentrations of di-n-butylpthalate (DBP) in indoor air and on several interior surfaces in a large number of residences and day-care centers. The DBP surface sorption data is used together with estimates of the available surface area of the different classes of materials found indoors to estimate the emission rate and evolving gas-phase concentration after the installation of vinyl flooring in a typical room. Because it is based on fundamental mechanisms and the properties of the specific SVOCs, simple variants of the model should ultimately be able to predict exposure to phthalate plasticizers, brominated flame retardants, biocides, and other SVOCs emitted from a wide range of consumer products and building materials. Although this work was reviewed by EPA and approved for publication, it may not necessarily reflect official agency policy.

VOCs Emission Simulation of Common Flooring Materials

Preliminary Investigation of Volatile Organic Compounds and Odor Emissions from Emulsion Paint and Laminate Flooring in Dynamic Environmental Chamber

Volatile organic compound emissions in building materials

Emissions of Semi-Volatile Organic Compounds from Architectural Coatings and Polyvinyl Chloride Floorings: Microchamber Method

Modeling Volatile Organic Compound (VOC) Concentrations Due to Material Emissions in a Real Residential Unit. Part I: Methodology and a Preliminary Case Study

Volatile Organic Compounds (VOCs) from Wood and Wood-Based Panels: Methods for Evaluation, Potential Health Risks, and Mitigation

Investigation on the source of VOCs emission from indoor construction materials using electronic sensors and TD-GC-MS

Simulation of Voc Emissions from Building Materials by Using the State-Space Method

Improving Material Selection for Residences Using Volatile Organic Compound Simulation at Design Stage: Field Verifications from a Unique Case Study

VOC emissions from two-layer building and vehicle cabin materials: Measurements and independent validation

Experimental assessment of modelling VOC emissions from particleboard into a ventilated chamber

Preliminary Study on the Emission Dynamics of TVOC and Formaldehyde in Homes with Eco-Friendly Materials: Beyond Green Building

VOC emission from a multi-layer work surface (panel) of a workstation system

Simulated Study on Typical Sources of Volatile Organic Compounds (vocs) in Indoor Air

Volatile Organic Compounds (Vocs) Concentration Simulation Of A Newly Decorated Residential Unit

Review of Numerical Simulation Method and Software for Indoor Volatile Organic Compounds (VOCs)

Emission of Phthalates from Polymer Materials and Interaction with Interior Surfaces

Composition and Correlation of Volatile Organic Compounds and Odor Emissions from Typical Indoor Building Materials Based on Headspace Analysis

Volatile Organic Compounds in Different Interior Construction Stages of an Apartment

Emission of volatile organic compounds from new furniture products and its impact on human health

VOC Emission Rates from an Indoor Surface Using a Flux Chamber and PTR-MS