Abstract:TS1-20 Abstract: A model has recently been proposed to predict the emission rate of semivolatile organic compounds (SVOCs) from polymer materials. The model was based on data collected in an experimental study that measured emissions of di-2-ethylhexyl phthalate (DEHP) from vinyl flooring. The analysis revealed that although emissions of volatile organic compounds (VOCs) are generally subject to “internal” control (the material-phase diffusion coefficient), emissions of the very low volatility SVOCs (such as DEHP) are subject to “external” control (partitioning into the gas phase, the convective mass-transfer coefficient, and adsorption onto interior surfaces). The analysis showed that adsorption to interior surfaces strongly influences the emission rate. This inference is supported by the recent experimental finding that the presence of indoor dust increases the emission rate of DEHP from vinyl flooring in a test chamber. Compared with the 2 simple chamber systems studied, a regular indoor environment has many other types of surface that will adsorb SVOCs to different extents. The emission rate measured in the test chambers may therefore be vastly different from the actual emission rate from the exact same material into a typical indoor environment. The new model provides a convenient means to estimate the true emission rate and evolving gas phase and adsorbed surface concentrations likely to occur in real indoor environments. The missing information is the adsorption isotherm for DEHP on the different types of indoor surfaces. Although very little information is available on adsorption of DEHP and other SVOCs to indoor surfaces, the recent EPA-sponsored Children's Total Exposure to Persistent Pesticides and Other Persistent Organic Pollutants (CTEPP) study has measured concentrations of di-n-butylpthalate (DBP) in indoor air and on several interior surfaces in a large number of residences and day-care centers. The DBP surface sorption data is used together with estimates of the available surface area of the different classes of materials found indoors to estimate the emission rate and evolving gas-phase concentration after the installation of vinyl flooring in a typical room. Because it is based on fundamental mechanisms and the properties of the specific SVOCs, simple variants of the model should ultimately be able to predict exposure to phthalate plasticizers, brominated flame retardants, biocides, and other SVOCs emitted from a wide range of consumer products and building materials. Although this work was reviewed by EPA and approved for publication, it may not necessarily reflect official agency policy.

Emission of Phthalates from Polymer Materials and Interaction with Interior Surfaces