Abstract:Rock strength is generally divided into the components of cohesion and internal friction. These components are two important parameters for estimating the damaged or disturbed zone around an excavation and its corresponding support design. However, the cohesive and frictional strength components at the same strain increment before peak strength are difficult to separate from each other. In addition, the misperception of their mutual evolution has been in existence for a long time. A numerical code, Rock Failure Process Analysis (RFPA2D), based on the finite element method was used in this study to clarify this misperception. The RFPA2D approach can account for rock heterogeneity and capture the entire rock failure process without prior assumptions regarding where and how microcracks and fracturing develop. Numerical models of rock were copied and reused in uniaxial and biaxial tests to create identical heterogeneous models for use under different confining stress conditions. Forty-five numerical tests (5 homogeneity indexes × 9 confining pressures) were used to calculate the results of the principal stresses (σ1 and σ3) at specified increments of axial strain. The intercept and the slope of a linear line fitting to the principal stresses at the same strain before peak strength were obtained in the principal stress space. The intercept is related to the cohesive strength component of the shear resistance, and the slope of the linear line is a pseudo-internal friction coefficient. Through the analysis of the linear fitting results, it has been found that the cohesive strength component increases while the pseudo-internal friction coefficient decreases with increasing homogeneity index of the numerical rock models. The values of cohesion and internal friction vary as a function of the strain state, and they are immediately activated with a strain increment before peak strength. The research results strengthen the understanding of the mobilization of the load-bearing capacity of rock mass surrounding an opening and can improve the design of practical support systems.

Numerical study of related factors affecting mechanical properties of fractured rock mass and its sensitivity analysis

Development of a shear strength model for a rock mass containing a complex fracture system based on direct shear tests: a case study

Sensitivity Analysis of the Influences of Rock Mechanical Parameters on the Deformation of Underground Caverns

Influences of foliation orientation and lateral stress difference on the deformation and fracturing of a thin-layered rock around underground excavations: insight from multi-axial loading tests

3D Digital Analysis of Cracking Behaviors of Rocks through 3D Reconstruction Model under Triaxial Compression

Electrical properties and modeling of single-fractured rocks under thermal-hydro-mechanical coupling

Study the anisotropic behavior of layered surrounding rock based on 3D FDEM method

Numerical simulation of true triaxial unilateral unloading effect of fractured rock

Numerical Analysis of Mechanical Response Characteristics of Jointed Tunnel Surrounding Rock under Dynamic Loading

Comparative Study of Phase Change Theory and Zonal Fracturing Field Measurements in Deep Surrounding Rocks

Study on multi-scale damage and failure mechanism of rock fracture penetration: experimental and numerical analysis

Numerical study of the evolution of cohesion and internal friction in rock during the pre-peak deformation process

Experimental study on the mechanical and failure behaviors of deep rock subjected to true triaxial stress: A review

Rock failure deformation characteristics and mechanical parameter prediction of Xujiahe formation gas reservoir in Tianfu area, Sichuan Basin

Excavation-induced deep hard rock fracturing: Methodology and applications

A novel anisotropic deterioration mechanical model for rock ductile–brittle failure under 3D high-stress and its application

Grey relation analysis of deformation sensitivity based on probability distribution models of surrounding rock mechanical parameters

Numerical study on spalling failure of rock surrounding deep buried tunnel based on DEM

Effect of Lateral Stress on the Mechanical Properties of Rock Fracture and Its Implication on the Stability of Underground Oil Storage Caverns

Study on the influence of pore water pressure on shear mechanical properties and fracture surface morphology of sandstone

Multiscale fracture characteristics and failure mechanism quantification method of cracked rock under true triaxial compression