Abstract:Muon imaging technology has developed rapidly over the past decades with extensive applications. In many cases, plastic scintillator detectors are preferred because of their high cost performance, ease of processing and robustness in harsh environments. To reduce imaging time and improve imaging quality, detectors tend to have large areas and high position resolutions. The challenge to the electronics for such detectors is to maintain the scale of electronics acceptable while improving the high position resolution of the detector. In this paper, the basic detector unit is a triangular strip of plastic scintillator, each embedded with two wavelength-shifting (WLS) fibers read out by the silicon photomultipliers (SiPMs). Since the hit position of muon on the detector is determined by the splitting ratio of the scintillation light on two adjacent scintillator strips, it is necessary the readout electronics has high linearity and low noise. The possibility of the electronics channel multiplexing on the same detector plane is fully explored so that four WLS fibers can be read out by one SiPM realizing 2:1 readout channel compression. Furthermore, since multiple electronics modules are connected by a daisy chain structure, the electronics system is very scalable with its data acquisition system (DAQ) independent of detector size. In addition to detailing the position encoding readout scheme, the design of electronics module and the DAQ system, the electronics system has been implemented and applied to a prototype detector for performance evaluation. Using scintillator strips with 11 mm pitch size, the position resolution of the detector reaches 1.49 mm, which demonstrates that the designed electronics is suitable for the new detector structure, and the combination of the two has a good application prospect in muon imaging.

Design and evaluation of prototype readout electronics for nuclide detector in Very Large Area Space Telescope

Prototype Design of Readout Electronics for In-Beam TOF-PET of Heavy-Ion Cancer Therapy Device

Design of a high-dynamic-range prototype readout system for VLAST calorimeter

Simulation study of performance of the Very Large Area gamma-ray Space Telescope

Beam Test of a Monolithic Active Pixel Sensor for the CEPC Vertex Detector

Prototype of Readout Electronics for GAEA Gamma Spectrometer of Back-n Facility at CSNS

Data Acquisition System for CEPC Vertex Detector Prototype

A Full Functional Monolithic Active Pixel Sensor Prototype for the CEPC Vertex Detector

Electronics design for a muon imaging system using triangular plastic scintillators with WLS fiber readouts

Test of the prototype of electron detector for LHAASO project using cosmic rays

New prototype scintillator detector for the Tibet AS$γ$ Experiment

Design and Performances of Prototype Muon Detectors of Lhaaso-Km2a

New prototype scintillator detector for the Tibet ASγ experiment

Design of Prototyping PMT Electronic System for Daya Bay Reactor Neutrino Experiment

Design and implementation of a ground detection system for HERD-TRD front-end electronics

Design of a Multi-Anode Microchannel Array Detector System

An Analogue Front-End ASIC Prototype Designed For PMT Signal Readout

Conceptual design and progress of transmitting $\sim$ MV DC HV into 4 K LHe detectors

Design of a triggerless readout electronics system for CDEX-50

The Research and Development of a Prototype Cosmic Ray Muon Tomography Facility with Large Area MRPC Detectors

Design of a Prototype in-situ Gamma-ray Spectrometer for Deep Sea