Abstract:The relatively poor atomic-oxygen (AO) resistance of the standard polyimide (PI) films greatly limits the wide applications in low earth orbit (LEO) environments. The introduction of polyhedral oligomeric silsesquioxane (POSS) units into the molecular structures of the PI films has been proven to be an effective procedure for enhancing the AO resistance of the PI films. In the current work, a series of POSS-substituted poly (pyromellitic anhydride-4,4′-oxydianiline) (PMDA-ODA) films (POSS-PI) with different POSS contents were synthesized via a POSS-containing diamine, N-[(heptaisobutyl-POSS)propyl]-3,5-diaminobenzamide (DABA-POSS). Subsequently, the effects of the molecular structures on the thermal, tensile, optical, and especially the AO-erosion behaviors of the POSS-PI films were investigated. The incorporation of the latent POSS substituents decreased the thermal stability and the high-temperature dimensional stability of the pristine PI-0 (PMDA-ODA) film. For instance, the PI-30 film with the DABA-POSS content of 30 wt% in the film exhibited a 5% weight loss temperature (T5%) of 512 °C and a coefficient of linear thermal expansion (CTE) of 54.6 × 10−6/K in the temperature range of 50–250 °C, respectively, which were all inferior to those of the PI-0 film (T5% = 574 °C; CTE = 28.9 × 10−6/K). In addition, the tensile properties of the POSS-containing PI films were also deteriorated, to some extent, due to the incorporation of the DABA-POSS components. The tensile strength (TS) of the POSS-PI films decreased with the order of PI-0 > PI-10 > PI-15 > PI-20 > PI-25 > PI-30, and so did the tensile modulus (TM) and the elongations at break (Eb). PI-30 showed the TS, TM, and Eb values of 75.0 MPa, 1.55 GPa, and 16.1%, respectively, which were all lower than those of the PI-0 film (TS = 131.0 MPa, TM = 1.88 GPa, Eb = 73.2%). Nevertheless, the incorporation of POSS components obviously increased the AO resistance of the PI films. All of the POSS-PI films survived from the AO exposure with the total fluence of 2.16 × 1021 atoms/cm2, while PI-0 was totally eroded under the same circumstance. The PI-30 film showed an AO erosion yield (Es) of 1.1 × 10−25 cm3/atom, which was approximately 3.67% of the PI-0 film (Es = 3.0 × 10−24 cm3/atom). Inert silica or silicate passivation layers were detected on the surface of the POSS-PI films after AO exposure, which efficiently prevented the further erosion of the under-layer materials.

Thermal Decomposition Behavior of Polyimide Containing Flame Retardant SiO2 and Mg(OH)2

Mechanical Properties and Thermal Degradation of Flame Retardant PC/HDPE Blending with Spirocyclic Hydroxybenzene Phosphate

Clarifying the effect of moisture absorption and high-temperature thermal aging on structure and properties of polyimide film at molecular dynamic level

Effect of high-temperature thermo-oxidation on the mechanical and electrical properties of phenylethynyl-terminated polyimide/carbon fiber composite

Thermal Degradation Behavior and Flame Retardancy of Polycarbonate Containing Poly[(phenylsilsesquioxane)-co-(dimethylsiloxane)] and Potassium Diphenyl Sulfonate

Thermal degradation of magnesium hydroxide and red phosphorus flame retarded polyethylene composites

Synergistic effects of polyoxometalate‐based ionic liquid‐doped sepiolite in intumescent flame‐retardant high‐density polyethylene

Dielectric Property and Charge Evolution Behavior in Thermally Aged Polyimide Films

Study on Thermal Oxygen Aging Characteristics and Degradation Kinetics of PMR350 Resin

Colorless and transparent semi‐alicyclic polyimide films with intrinsic flame retardancy based on alicyclic dianhydrides and aromatic phosphorous‐containing diamine: Preparation and properties

Preparation and Properties of Intrinsically Atomic-Oxygen Resistant Polyimide Films Containing Polyhedral Oligomeric Silsesquioxane (POSS) in the Side Chains

Thermal Degradation of Flame‐retarded Polyethylene/magnesium Hydroxide/poly(ethylene‐co‐propylene) Elastomer Composites

Investigation of the synergistic effect of red phosphorus and magnesium hydroxide on the thermal degradation behavior and flame resistance of the intumescent fire‐retardant polypropylene system

Preparation and Properties of Modified Phenylethynyl Terminated Polyimide with Neodymium Oxide.

Study on Effect of Polydimethylsiloxane in Intumescent Flame Retardant Polypropylene

Analysis of Thermal Degradation Kinetics of POM under Inert and Oxidizing Atmospheres and Combustion Characteristics with Flame Retardant Effects

Synthesis and Properties Comparison of Low Dielectric Silicon Containing Polyimides.

Investigation on flame‐retardant, thermal and mechanical properties of glass fiber reinforced polyimide composites

Thermal Stability of Epoxy Resins Containing Flame Retardant Components: an Evaluation with Thermogravimetric Analysis

Flammability and Thermal Degradation of Flame Retarded Polypropylene Composites Containing Melamine Phosphate and Pentaerythritol Derivatives

Flame retarding mechanism of polycarbonate containing methylphenyl-silicone