Abstract:This paper presents a detailed study on the transient response and stability of the automatic gain control (AGC) with a proportion-integral (PI) controller for a MEMS vibratory gyroscope, which constructs a closed-loop control system to make the gyroscope achieve a constant amplitude vibration at its resonant frequency. The nonlinear mathematical model for the control system is established by applying the averaging and linearization method, which is evaluated through numerical simulations. The stability and convergence characteristics of the whole loop are investigated by using the phase plane method and Routh-Hurwitz criterion. The analysis provides a quantitative methodology for selecting the system parameters to approach stability and an optimal transient response. The negative impact induced by drift of the resonant frequency and Q-factor is also discussed. Simulation results predicted by the model are shown to be in close agreement with the experimental results carried out on a doubly decoupled bulk micromachined gyroscope. By optimizing the control parameters, the measured rising time is less than 100 ms without obvious overshoot. The setting time of the whole loop is less than 200 ms with the relative fluctuation of velocity amplitude within approximately 16 ppm for an hour. The resulting overall performance of the gyroscope is tested under atmospheric pressure. The resonant frequencies and the Q-factor of the drive mode and sense mode are 2.986 kHz, 213 and 3.199 kHz, 233, respectively. The gyroscope achieves a scale factor of 27.6 mV/deg/s with nonlinearity less than 120 ppm in the full-scale range of 800 degrees s(-1). The threshold of sensitivity is measured to be about 0.005 degrees s(-1) with noise equivalent angular rate evaluated to be 0.001 degrees/s/Hz(1/2).

Bandwidth Expansion of Atomic Spin Gyroscope With Transient Response

Ultrahigh Bandwidth Measuring Approach of an I-FOG Based on Axial Magnetic Sensitivity.

One-time Frequency Sweep to Eliminate IQ Coupling in MEMS Vibratory Gyroscopes

A Slot-Structure MEMS Gyroscope Working at Atmosphere With Tunable Electrostatic Spring Constant

Progress on novel atomic magnetometer and gyroscope based on self-sustaining of electron spins

Hyperfine-enhanced gyroscope based on solid-state spins

Bandwidth Expansion Through Large-Amplitude Modulation and Proportional Feedback for Single-Beam Atomic Magnetometers

A Synchronous Spin-Exchange Optically Pumped NMR-Gyroscope

Bandwidth optimization design of a multi degree of freedom MEMS gyroscope

A High Sensitivity Closed-Loop Spin-Exchange Relaxation-Free Atomic Magnetometer With Broad Bandwidth

Cross-sensor feedback stabilization of an emulated quantum spin gyroscope

An Electrostatic Force Feedback Approach for Extending the Bandwidth of MEMS Vibratory Gyroscope

Self-Calibrated Atom-Interferometer Gyroscope by Modulating Atomic Velocities

Decoupling Control of Micromachined Spinning-Rotor Gyroscope with Electrostatic Suspension

Neural-Network-Based Constrained Output-Feedback Control for MEMS Gyroscopes Considering Scarce Transmission Bandwidth

Reanalyzing Atomic Beam Interferometric Gyroscopes: Dependence of Sensitivity on Experimental Parameters

Online asymmetry estimation for whole angle mode coriolis vibratory gyroscopes by high frequency injection

Spin Rate Effects In A Micromachined Electrostatically Suspended Gyroscope

Transient response and stability of the AGC-PI closed-loop controlled MEMS vibratory gyroscopes

Closed-loop measurement in atom interferometer gyroscope with velocity-dependent phase dispersion compensation