One-pot cellulose nanofibrillation, surface-modification and grafting by deep eutectic solvent towards high performance 3D printing nanocellulose-enriched bionanocomposites
Ruoteng Ma,Qing Zhang,Shaoning Wang,Bowen Li,Lisha Ma,Lili Zhang,Juan Yu,Yimin Fan,Zhiguo Wang
DOI: https://doi.org/10.1016/j.indcrop.2024.118134
IF: 6.449
2024-04-01
Industrial Crops and Products
Abstract:Fabrication of biodegradable nanocellulose-enriched polymer nanocomposite with 3D printable, strong, and tough properties is still challenging. Here, nanofibrillation, surface-modification and grafting of cellulose nanofibers was performed by using the "one-pot method" strategy in deep eutectic solvent of lactic acid/choline chloride (LA/ChCl) and lactic acid/choline chloride/ε-caprolactone (LA/ChCl/ε-CL) system respectively. The poly lactic acid grafted cellulose nanofibers (CNF-g-PLA) and poly ε-caprolactone grafted cellulose nanofibers (CNF-g-PCL) were successfully prepared. The CNF-g-PLA with a grafting ratio of 33.05% and an average diameter of 20 ∼ 40 nm was prepared in one-pot processing conditions of 110 ℃, 12 h and 2.5% addition of catalyssa'dt Sn (Oct)2. The dispersibility of obtained CNF-g-PLA and CNF-g-PCL were highly improved in organic solvents. Therefore, based on the interfacial compatibility of CNF-g-PLA and CNF-g-PCL, nanocellulose-enriched CNF-g-PLA/PLA composites and CNF-g-PCL/PCL composites were prepared. When the addition of CNF-g-PLA reached 20%, the tensile stress and strain of CNF-g-PLA/PLA composite increased the most to 58 ± 2.3 MPa and 13%, respectively. The tensile stress of CNF-g-PCL/PCL composite reached 19.36 ± 0.35 MPa. In addition, CNF-g-PLA/PLA composites and CNF-g-PCL/PCL composites can form complex patterns through 3D printing, such as hollow cylinders, complex polyhedrons, etc. This study broadens the application field of graft-modified nanocellulose and enables controllable 3D printing of nanocellulose-based composites.
agronomy,agricultural engineering