Effects of heat treatment on the mechanical properties of 3D-printed polylactic acid: Study of competition between crystallization and interlayer bonding
Ali Ghasemkhani,Gholamreza Pircheraghi,Nima Rashidi Mehrabadi,Asma Eshraghi
DOI: https://doi.org/10.1016/j.mtcomm.2024.109266
IF: 3.8
2024-05-19
Materials Today Communications
Abstract:Fused deposition modeling (FDM) is a popular additive manufacturing technique because of its flexibility, customization, cost-effectiveness, and eco-friendliness. However, due to the layer-by-layer fabrication process and the formation of voids, the mechanical properties of printed parts are lower than other manufacturing techniques. As a solution, heat treatments can effectively mitigate additive manufacturing limitations and improve the mechanical properties of printed parts. The interlayer bonding and subsequently mechanical properties of 3D-printed PLA were affected by the competition between crystallization and chain diffusion of 3D-printed polylactic acid during the heat treatment process. This competition highlights the importance of optimization of heat treatment. Additionally, crystallite growth could cause a reduction in some mechanical properties, like elongation. The size, distribution, and content of voids are also influenced by heat treatment, playing a crucial role in the mechanical properties of 3D-printed parts. In this research, printed samples were heat-treated at temperatures of 75 oC, 110 oC, and 130 oC for two hours. Furthermore, compression-molded samples were fabricated to inspect a comparison of mechanical properties between the traditional and additive manufacturing methods and investigate the effect of layer-by-layer fabrication on these properties. Sample AM-75 showed a 15.5% improvement in bonding strength compared to the non-annealed printed sample, resulting in an increase of 20.2% in tensile strength and 275% in impact strength. Moreover, annealing the sample at 130 oC resulted in a 7.6% reduction in porosity and a significant improvement of 220% in crystallinity, heat deflection temperature, flexural modulus, and flexural strength, with improvements of 121%, 29.5%, and 15.2% respectively.
materials science, multidisciplinary