Abstract:High-temperature alkali-metal heat pipes are passive heat transfer devices, where the capillary pressure created by the menisci in the wick pumps the condensed fluid back to the evaporator. Thus, the heat pipe heat transfer capacity is limited by the maximum capillary pressure at high heat fluxes. This work presents a two-dimensional heat and mass transfer model for alkali metal heat pipes. In addition to the traditional wall heat conduction model, the model also incorporates gas-liquid flow heat transfer and capillary structure models, enabling the model to simulate both steady-state operation and transient capillary limit processes. The predictions of the model agreed well with experimental data. The predicted critical heat flux temperature has an error of less than 20 & DEG;C and a relative error of 6%. The predicted transient sequences are consistent with the measurements. The model shows that capillary limit is affected by inclination angle, heat flux, and wick structure. For inclinations, the critical heat flux at the capillary limit is linearly related to the inclination angle with the predicted temperature rising 2-10 & DEG;C/s during the early stage of the capillary limit critical heat flux condition. The evaporator temperature oscillates before the capillary limit with positive inclinations. For heat fluxes, increasing the heat flux by 17% increases the temperature increase rate 10 fold with a longer dryout length. The evaporator exhibits hysteresis after the capillary limit due to partial dryout of evaporator. For wick structures, reducing the mesh screen pitch from 80 & mu;m to 15 & mu;m reduces the critical heat flux to 10% of the CHF at 80 & mu;m. This model can accurately predict the heat pipe temperature variations at the capillary limit and can explain the physical mechanisms for the dryout oscillations and recovery hysteresis at the capillary limit. Thus, the measurements and model provide analytical guidelines for designing heat pipe cooling systems.

Development of Selection Methods for the Primary and Secondary Capillary Structures of Loop Heat Pipes

Simulation of Steady-State Operation of an Ejector-Assisted Loop Heat Pipe with a Flat Evaporator for Application in Electronic Cooling

Numerical investigation on transient and steady phase change heat transfer in the evaporator of a loop heat pipe

Three-Dimensional Numerical Study on the Flow and Heat Transfer in Wick of Loop Heat Pipe

Heat Transfer Capacity Optimization Design of Microgroove and Microcolumn in an Ultra-Thin Flat Heat Pipe

Numerical exploration of optimal microgroove shape in loop-heat-pipe evaporator

Investigation on Heat and Mass Transfer in A Evaporator of A Capillary-Pumped Loop with the Lattice Boltzmann Method: Pore Scale Simulation

Investigation on Microheat Pipe Array with Arteries

Experimental Study on an Thermosyphon Loop with Bubble Pump Effect

The Study of Condensation Processes in the Low-Temperature Short Heat Pipes with a Nozzle-Shaped Vapour Channel

A two-phase three-field modeling framework for heat pipe application in nuclear reactors

Transient Analysis of A Cylindrical Heat Pipe Considering Different Wick Structures

Experimental research on the thermal performance of a flat evaporator loop heat pipe with a new composite wick

Parametric Study on Ammonia-Based Loop Heat Pipe

Design of a Novel Turbine-Pump-driven Loop Heat Pipe and Its Thermodynamic Analysis

Design Optimization of Gap Distance for the Capillary Limitation of a Heat Pipe with Annular-Type Wick Structure

Experimental study on the characteristics of loop heat pipe with modified carbon fiber felt wick

An Improved Model of the Heat Pipe Based on the Network Method Applied on a Heat Pipe Cooled Reactor

A study of liquid flow in a flat plate heat pipe under localized heating

Capillary Limit of a Sodium Screen-Wick Heat Pipe

Design and Analysis of Heat Pipe Heat Exchanger Efficiency