Abstract:This paper is a review of the work conducted at Auburn University in the study of refractory metal single crystals. Refractory metals and intermetallic alloys are important in high temperature engineering systems where deformation must be maintained at a low level. This review focus on two approaches. The first is based on a traditional float zone melting method with a focused electron beam as the heat source. This method requires the melting and solidification of the material in a controlled manner and is therefore power intensive. This method was used to successfully process both single phase Ni3Al intermetallic compound and molybdenum base refractory metals in the single crystalline form. Due to the Complex Ni3Al phase diagram, slight variations in the compositions resulted in significant difference in the growth characteristics. In the case of molybdenum alloys, the ease of single crystal formation depends on the selection of the solute. The growth characteristics and parameters for processing these alloys will be presented and discussed. The second method used is a chemical vapor deposition (CVD) approach based on the reduction of selected chlorides and fluorides of the refractory metals at significantly lower temperatures. In the latter approach, refractory metal depositions were made using a flowing system. Results presented in this paper will concentrate on the production of tungsten single crystal layers using this technique. A comprehensive analysis for the effects of operating parameters on single crystal layer growth has been conducted and optimized growth conditions have been achieved. Characterization of the processed materials was conducted using a variety of techniques including x-ray diffraction and electron microscopy with energy dispersive analysis.

Production of Single-Crystal Seeds [001] from Nickel–Tungsten Alloys by Directional Crystallization

Orientation Control for Nickel-Based Single Crystal Superalloys: Grain Selection Method Assisted by Directional Columnar Grains

Development of a High-Efficiency Z-Form Selector for Single Crystal Blades and Corresponding Grain Selection Mechanism

Mechanism of Heterogeneous Substrate Stimulating Growth for Nickel-Based Single Crystal Superalloy

Seeded Growth of AlN Crystals on Nonpolar Seeds Via Physical Vapor Transport

Temperature Field Evolution of Seeding during Directional Solidification of Single-Crystal Ni-Based Superalloy Castings

Modeling of Unidirectional Growth in a Single Crystal Turbine Blade Casting

Substrate stimulating technique for Ni-based single crystal superalloy preparation during direction solidification

Improvement of Hydrogen-Resistant Gas Turbine Engine Blades: Single-Crystal Superalloy Manufacturing Technology

Compositions of Gamma and Gamma Prime Phases in an As-Cast Nickel-Based Single Crystal Superalloy Turbine Blade

Recrystallization of Single Crystal Nickel-based Superalloys

Effect of Directional Solidification Variables on the Microstructures of Single-Crystal Turbine Blades of Nickel-Based Superalloy

From research to cost-effective directional solidification and single-crystal production – an integrated approach

Innovations in Casting Techniques for Single Crystal Turbine Blades of Superalloys

A Method for Increasing the Supersolvus Critical Strain for Recrystallization in Single-Crystal Superalloys

Processing And Growth Of Refractory Single Crystals

Feasibility of Integrated Seed Making and Directional Solidification of Tial Alloy Using Cold Crucible

Investigation of the Undercoolability of Ni-Based Alloys Using High Temperature Thermal Analysis

Vaporization of Ni, Al and Cr in Ni-Base Alloys and Its Influence on Surface Defect Formation During Manufacturing of Single-Crystal Components

Refractory high-entropy nanoalloys with exceptional high-temperature stability and enhanced sinterability

Growth Of Single-Crystalline Tungsten Nanowires By An Alloy-Catalyzed Method At 850 Degrees C