Abstract:This paper reports that starter block with smaller diameter has better optimization effect of grain orientation during directional solidification of nickel‐based single‐crystal superalloy, and the single‐crystal appears at less than half‐turn position of spiral passage. Based on this, a spiral grain selector with optimized geometry is designed which is beneficial to practical production. A spiral grain selector with excellent geometric parameters can ensure qualified single‐crystal (SX) is selected while decreasing lesser thermal gradient (G) during casting of SX nickel‐based superalloy . In this paper, three configurations of spiral grain selectors with different height of starter block (H = 18, 25, 35 mm) and same spiral passage are adopted. Based on the quantitative analysis of orientation distribution of grains in starter block, it is found that the deviation of oriented grains in the projection zone of spiral passage inlet (circle with a diameter of 4 mm) are smaller than grains of overall cross‐section (circle with a diameter of 10 mm), which verify that starter block with smaller diameter have better optimization effect of grain orientation. Moreover, the average deviation of oriented grains decreases to a range of 6.6–10.8° when the height of starter block is 18–27 mm, and SX selection is completed on the position of less than half turn in spiral passage regardless of the number of grains in the inlet position. Finally, a modified spiral grain selector is designed from the perspective of practical production, of which total height is reduced by at least 15 mm, and can decrease lesser G at some extent during casting .

Substrate stimulating technique for Ni-based single crystal superalloy preparation during direction solidification

Effect of Directional Solidification Methods on Solid Solution Window in Ni-based Single-Crystal Superalloy

Mechanism of Heterogeneous Substrate Stimulating Growth for Nickel-Based Single Crystal Superalloy

Grain Orientation Optimization Of Two-Dimensional Grain Selector During Directional Solidification Of Ni-Based Superalloys

Orientation Control for Nickel-Based Single Crystal Superalloys: Grain Selection Method Assisted by Directional Columnar Grains

Orientation controlling of Ni-based single-crystal superalloy by a novel method: grain selection assisted by un-melted reused seed

Grain Selection During Casting Ni-Base, Single-Crystal Superalloys with Spiral Grain Selector

Orientation Characteristics of Single Crystal Superalloys with Different Preparation Methods

Microstructural Investigations of Ni-Based Superalloys by Directional Solidification Quenching Technique

Optimizing process windows for minimizing the pore size of Ni-based single crystal superalloys

Simulation of Grain Selection During Single Crystal Casting of A Ni-Base Superalloy

Ebsd Studies of Grain Evolution and Grain Selection Behavior During the Preparation of Ni-Based Single Crystal Superalloy Dd3

Simulation of grain selection during solidification of Ni base single crystal superalloy in spiral grain selector

Processing, Microstructures and Mechanical Properties of a Ni-Based Single Crystal Superalloy

A Geometry Optimization of Spiral Grain Selector During Directional Solidification of Nickel‐Based Superalloy

A High Thermal Gradient Directional Solidification Method for Growing Superalloy Single Crystals

Temperature Field and Microstructure Simulation of Directional Solidification Process of Single Crystal Blade Prepared Efficiently with Different Module Structures

Effect of Competitive Crystal Growth on Microstructural Characteristics of Directionally Solidified Nickel-Based Single Crystal Superalloy

Experimental Investigation on Recrystallization Mechanism of a Ni-base Single Crystal Superalloy

Study on the Temperature Field and Grain Structure of Large-Scale DZ466 Ni-Based Superalloy During Directional Solidification Process

Optimization of Grain-Selection Behavior in the Spiral Selector During Cusp-Magnetic-Field-Assisted Directional Solidification of Single-Crystal Superalloy