Wear behaviour of graphene platelets reinforced WC-Co cemented carbide

Meng Li,Zanlin Cheng,Ján Dusza,Zhuolin Song,Fangkun Xiao,Manfeng Gong,Shangyue Sun,Chengyu Zhang

DOI: https://doi.org/10.1080/17436753.2022.2121531

2022-09-13

Advances in Applied Ceramics

Abstract:The wear behaviour of WC-Co cemented carbide reinforced with graphene platelets (WC-Co-GPLs composite) was investigated. The tribological parameters as friction coefficient and wear rate were measured using a ball-on-plate configuration with different contact loads. The microstructures and worn surfaces of composites were studied. The WC-Co-GPLs composite exhibits significantly better tribological properties in comparison to the WC-Co which is most evident at contact load of 80 N, where the friction coefficient and wear rate of the WC-Co-GPLs composite are 0.339 and 9.27 × 10 −6 mm 3 ·(m·N) −1 , respectively. The improvement in wear behaviour of WC-Co-GPLs composite is attributed to the formation of the tribofilm during the wear test and enhancement of mechanical properties of the WC-Co-GPLs composite. The pulled-out GPLs attaches on the worn surface contribute to the formation of tribofilms during tribology test, especially at higher loads. The tribofilms protect the WC-Co-GPLs from wear and guarantee the integrity of the worn surface.

materials science, ceramics