Abstract:Copper–indium gallium disulfide (CIGS) is a good absorber for photovoltaic application. Thin films of CIGS were prepared by spray pyrolysis on glass substrates in the ambient atmosphere. The films were characterized by different techniques, such as structural, morphological, optical and electrical properties of CIGS films were analyzed by X-ray diffraction (XRD), scanning electron microscopy (SEM), atomic force microscopy (AFM), spectrophotometer and Hall effect, respectively. After optimization, the deposited films structure, grain size, and crystallinity became more important with an increase of annealing time at 370 °C for 20 min. Transmission electron microscopy (TEM) analysis shows that the interface sheets are well crystallized and the inter planer distance are 0.25 nm, 0.28 nm, and 0.36 nm. The atomic force microscopy (AFM) observation shows that the grain size and roughness can be tolerated by optimizing the annealing time. The strong absorbance and low transmittance were observed for the prepared films with a suitable energy bandgap about 1.46 eV. The Hall effect measurement system examined that CIGS films exhibited optimal electrical properties, resistivity, carrier mobility, and carrier concentration which were determined to be 4.22 × 106 Ω cm, 6.18 × 102 cm2 V−1 S−1 and 4.22 × 106 cm−3, respectively. The optoelectronic properties of CIGS material recommended being used for the photovoltaic application.

Comparison of optical properties of CdS thin films synthesized by spray pyrolysis and thermal evaporation method

Comparison of CdS nano films deposited by thermal evaporation and spray pyrolysis techniques

Optical Properties of CuCdS Thin Film Prepared by Vacuum Thermal Evaporation Technique

Structural and Optical Properties of Polycrystalline CdS Thin Films Deposited by Electron Beam Evaporation

Optical behaviour of sprayed tin sulphide thin films

Optical and Electrical Properties of CdS Films

To Study the Cadmium Sulphide Thin Films Synthesis by Simple Spin Coating Method for Energy Application

[Study of the Physical Properties of SnS Thin Films Deposited by Ultrasonic Spray Pyrolysis Method].

Optical Transmission, Photoconductivity, and Morphology of Chemical Bath-Deposited CdS Thin Films for Optoelectronic Applications

Structural and electrical properties of CdS thin films spin coated on glass substrates

Effect of molarity on the optical and structural properties of CdS thin films deposited by spray pyrolysis on flexible plastic substrates

Structural, Optical and Photoelectric Properties of Nano-Crystalline Cds Thin Films Deposited by Electron Beam Evaporation

Preparation and Characterization of CdS by Evaporation and Cu2S Complex Photoelectric Thin Films

Electronic and Optical Properties of CdS Films Deposited by Evaporation

Structural and optical properties of CdS thin films prepared by RF sputtering

Optical and structural investigation of ZnS:Cu thin films synthesized by spray pyrolysis

Preparation of In_2S_3 Thin Films by Ultrasonic Spray Pyrolysis and the Influence of Post Rapid Thermal Process

The photovoltaic properties of novel narrow band gap Cu2SnS3 films prepared by a spray pyrolysis method

Optoelectronic characterization of CuInGa(S)2 thin films grown by spray pyrolysis for photovoltaic application

Cds Thin Films Deposited by Cbd Method on Glass

Deposition of Nanostructured CdS Thin Films by Thermal Evaporation Method: Effect of Substrate Temperature