Abstract:Cadmium sulfide (CdS) is an important semiconductor for electronic and photovoltaic applications, particularly when utilized as a thin film for window layers in CdTe solar cells. Deposition of thin-film CdS through the decomposition of single-source precursors is an attractive approach due to the facile, low-temperature, and rapid nature of this approach. Tailoring the precursor to affect the decomposition properties is commonly employed to tune desirable temperatures of decomposition. However, altering the precursor structure and the effect this has on the nature of the deposited material is an area far less commonly investigated. Here, we seek to investigate this by altering the ligands around the Cd metal center to increase the steric hindrance of the precursor and investigate the effect this has on the decomposition properties and the properties of deposited thin-film CdS from these precursors. For this, we report the synthesis of four CdS precursors with xanthate and pyridyl ligands ([Cd(n-ethyl xanthate)2(3-methyl pyridine)2] [1], [Cd(n-ethyl xanthate)2(3,5-lutidine)2] [2], [(Cd2(isopropyl xanthate)4(3-methyl pyridine)2)n] [3], and [Cd(isopropyl xanthate)2(3,5-lutidine)2] [4]). These single-source precursors for CdS were fully characterized by elemental analysis, NMR spectroscopy, single-crystal X-ray diffraction (XRD), and thermogravimetric analysis. It was found that even with subtle alterations in the xanthate (n-ethyl to isopropyl) and pyridine (3-methyl and 3,5-dimethyl) ligands, a range of hexa-coordinate precursors were formed (two with cis configuration, one with trans configuration, and one as a one-dimensional (1D) polymer). These four precursors were then used in aerosol-assisted chemical vapor deposition (AACVD) and spin-coating experiments to deposit eight thin films of CdS, which were characterized by Raman spectroscopy, powder X-ray diffraction, and scanning electron microscopy. Comparative quantitative information concerning film thickness and surface roughness was also determined by atomic force microscopy. Finally, the optical properties of all thin films were characterized by ultraviolet-visible (UV-Vis) absorption spectroscopy, from which the band gap of each deposited film was determined to be commensurate with that of bulk CdS (ca. 2.4 eV).

Comparison of CdS nano films deposited by thermal evaporation and spray pyrolysis techniques

Comparison of optical properties of CdS thin films synthesized by spray pyrolysis and thermal evaporation method

[Study of the Physical Properties of SnS Thin Films Deposited by Ultrasonic Spray Pyrolysis Method].

Preparation and characterization of CdS prepared by hydrothermal method

Preparation of In_2S_3 Thin Films by Ultrasonic Spray Pyrolysis and the Influence of Post Rapid Thermal Process

Deposition of Nanostructured CdS Thin Films by Thermal Evaporation Method: Effect of Substrate Temperature

Effect of molarity on the optical and structural properties of CdS thin films deposited by spray pyrolysis on flexible plastic substrates

Preparation of CdxInxS nanocomposite film by electron beam deposition

The Effect of the Ratio of Thiourea to Cd2+ on the Properties of CdS Nanoparticles

Optical Properties of CuCdS Thin Film Prepared by Vacuum Thermal Evaporation Technique

The Nanostructure Based SnS Chalcogenide Semiconductor: A Detailed Investigation of Physical and Electrical Properties

Deposition of nano-crystalline Cu2ZnSnS4 thin film in one step without sulfurization: Future prospects

CuS p- type thin film characterization deposited on Ti, ITO and glass substrates using spray pyrolysis deposition (SPD) for light emitting diode (LED) application

Optical and structural investigation of ZnS:Cu thin films synthesized by spray pyrolysis

To Study the Cadmium Sulphide Thin Films Synthesis by Simple Spin Coating Method for Energy Application

Synthesis of CdS nanoparticles in water/DMF medium: an investigation on the effect of time and microwave irradiation

Optoelectronic characterization of CuInGa(S)2 thin films grown by spray pyrolysis for photovoltaic application

Synthesis and characterization of F-doped CdS thin films by spray pyrolysis for photovoltaic applications

Preparation of CdS Nanoparticles by Hydrothermal Method in Microemulsion

Investigating the Effect of Steric Hindrance within CdS Single-Source Precursors on the Material Properties of AACVD and Spin-Coat-Deposited CdS Thin Films

Preparation and characteristics of CdS thin films by dip-coating method using its nanocrystal ink