Abstract:Powered ankle-foot prostheses can often reduce the energy cost of walking by assisting with push-off. However, focus on providing mechanical work may lead to ignoring or exacerbating common issues with chronic pain, irritation, pressure ulcer development, and eventual osteoarthritis in persons with amputation. This paper presents the design and validation of a novel transtibial prosthesis informed by predictive biomechanical simulations of gait which minimize a combination of user effort and interaction loading from the prosthesis socket. From these findings, the device was designed with a non-biomimetic anterior-posterior translation degree of freedom with a 10 cm range of motion which is primarily position-controlled to change the alignment of the prosthetic foot with the residual limb. The system is both mobile and tethered, with the batteries, actuators, and majority of electronics located in a small backpack. Mechanical loads are transmitted through cables to the prosthesis, minimizing the distal mass carriage required. We measured torque and force sensing accuracy, open loop actuator performance, closed loop torque and position control bandwidth, and torque and position tracking error during walking. The system is capable of producing up to 160 N-m of plantarflexion torque and 394 N of AP translation force with a closed loop control bandwidth of about 7 Hz in both degrees of freedom. Torque tracking during walking was accurate within about 10 N-m but position tracking was substantially affected by phase lag, possibly due to cable slack in the bidirectional mechanism. The prototype was capable of replicating our simulated prosthesis dynamics during gait and offers useful insights into the advantages and the practical considerations of using predictive biomechanical simulation as a design tool for wearable robots.

The control methods of Knee‐Ankle‐Toe Active Transfemoral Prosthesis in stance phase

Driving Coordination Between the Knee and Ankle Joints During Tiptoe Support Phase for Bipedal Robots Sprinting

On the Design of a Powered Transtibial Prosthesis with Stiffness Adaptable Ankle and Toe Joints.

Model-free robust adaptive integral sliding mode impedance control of knee-ankle-toe active transfemoral prosthesis

Mechanism and Controller Design of a Transfemoral Prosthesis with Electrohydraulic Knee and Motor-Driven Ankle

Effects of toe stiffness on ankle kinetics in a robotic transtibial prosthesis during level-ground walking

Energy-Efficient Braking Torque Control of Robotic Transtibial Prosthesis

A Sagittal Planar Ankle-Foot Prosthesis with Powered Plantarflexion and Socket Alignment

Finite-State Control of Powered Below-Knee Prosthesis with Ankle and Toe

Design, Kinematics and Gait Analysis, of Prosthetic Knee Joints: A Systematic Review

Adaptive Robust Force Position Control for Flexible Active Prosthetic Knee Using Gait Trajectory

A Piecewise Monotonic Gait Phase Estimation Model for Controlling a Powered Transfemoral Prosthesis in Various Locomotion Modes

Investigation of Knee Torque Dynamics in Single‐Leg Transfemoral Prosthetic during Walking Using Mathematical Modeling

Walk the Walk: A Lightweight Active Transtibial Prosthesis

An Energy-Efficient Torque Controller Based On Passive Dynamics Of Human Locomotion For A Robotic Transtibial Prosthesis

A Lightweight Powered Knee Prosthesis Replicating Early-Stance Knee Flexion During Level Walking

Design, Manufacture, and Experimental Validation of a Hydraulic Semi-Active Knee Prosthesis

Design and Evaluation of a Novel Microprocessor-Controlled Prosthetic Knee

Finite-state control of a robotic transtibial prosthesis with motor-driven nonlinear damping behaviors for level ground walking

Design, Control, and Validation of a Polycentric Hybrid Knee Prosthesis

Design, Characterization, and Preliminary Assessment of a Two-Degree-of-Freedom Powered Ankle-Foot Prosthesis