Abstract:Powered ankle-foot prostheses can often reduce the energy cost of walking by assisting with push-off. However, focus on providing mechanical work may lead to ignoring or exacerbating common issues with chronic pain, irritation, pressure ulcer development, and eventual osteoarthritis in persons with amputation. This paper presents the design and validation of a novel transtibial prosthesis informed by predictive biomechanical simulations of gait which minimize a combination of user effort and interaction loading from the prosthesis socket. From these findings, the device was designed with a non-biomimetic anterior-posterior translation degree of freedom with a 10 cm range of motion which is primarily position-controlled to change the alignment of the prosthetic foot with the residual limb. The system is both mobile and tethered, with the batteries, actuators, and majority of electronics located in a small backpack. Mechanical loads are transmitted through cables to the prosthesis, minimizing the distal mass carriage required. We measured torque and force sensing accuracy, open loop actuator performance, closed loop torque and position control bandwidth, and torque and position tracking error during walking. The system is capable of producing up to 160 N-m of plantarflexion torque and 394 N of AP translation force with a closed loop control bandwidth of about 7 Hz in both degrees of freedom. Torque tracking during walking was accurate within about 10 N-m but position tracking was substantially affected by phase lag, possibly due to cable slack in the bidirectional mechanism. The prototype was capable of replicating our simulated prosthesis dynamics during gait and offers useful insights into the advantages and the practical considerations of using predictive biomechanical simulation as a design tool for wearable robots.

On the Design of a Powered Transtibial Prosthesis with Stiffness Adaptable Ankle and Toe Joints.

Optimal Design and Analysis of a Powered Ankle-Foot Prosthesis with Adjustable Actuation Stiffness

Design of a Powered Ankle-Foot Prosthesis with an Adjustable Stiffness Toe Joint

Effects of toe stiffness on ankle kinetics in a robotic transtibial prosthesis during level-ground walking

A Sagittal Planar Ankle-Foot Prosthesis with Powered Plantarflexion and Socket Alignment

PANTOE II: IMPROVED VERSION OF A POWERED TRANSTIBIAL PROSTHESIS WITH ANKLE AND TOE JOINTS

Design, Characterization, and Preliminary Assessment of a Two-Degree-of-Freedom Powered Ankle-Foot Prosthesis

PANTOE 1: Biomechanical Design of Powered Ankle-Foot Prosthesis with Compliant Joints and Segmented Foot

Simulation and Analysis of a Full-Active Electro-Hydrostatic Powered Ankle Prosthesis

A Robotic Transtibial Prosthesis with Equilibrium-Adjustable Parallel Springs to Improve Energy Efficiency in Slope Walking

Walk the Walk: A Lightweight Active Transtibial Prosthesis

DEVELOPMENT OF BIOMIMETIC POWERED ANKLE-FOOT PROSTHESIS WITH COMPLIANT JOINTS AND SEGMENTED FOOT

A Novel Design of Electro-hydraulic Driven Active Powered Ankle-Foot Prosthesis

Gait-based Design and Human-machine Simulation of a Powered Hybrid Transfemoral Prosthetic Mechanism

Design, Optimization and Energetic Evaluation of an Efficient Fully Powered Ankle-Foot Prosthesis with a Series Elastic Actuator

Importance of series elasticity in a powered transtibial prosthesis with ankle and toe joints

Energy-Efficient Braking Torque Control of Robotic Transtibial Prosthesis

An Active-passive Lightweight Prosthesis Simulating Normal Human Walking Gait

Design and Optimization of A Powered Ankle-Foot Prosthesis Using A Geared Five-Bar Spring Mechanism

Design, Simulation and Kinematic Verification of a Multi-Loop Ankle-Foot Prosthetic Mechanism

A Lightweight Powered Knee Prosthesis Replicating Early-Stance Knee Flexion During Level Walking