Abstract:Powered ankle-foot prostheses can often reduce the energy cost of walking by assisting with push-off. However, focus on providing mechanical work may lead to ignoring or exacerbating common issues with chronic pain, irritation, pressure ulcer development, and eventual osteoarthritis in persons with amputation. This paper presents the design and validation of a novel transtibial prosthesis informed by predictive biomechanical simulations of gait which minimize a combination of user effort and interaction loading from the prosthesis socket. From these findings, the device was designed with a non-biomimetic anterior-posterior translation degree of freedom with a 10 cm range of motion which is primarily position-controlled to change the alignment of the prosthetic foot with the residual limb. The system is both mobile and tethered, with the batteries, actuators, and majority of electronics located in a small backpack. Mechanical loads are transmitted through cables to the prosthesis, minimizing the distal mass carriage required. We measured torque and force sensing accuracy, open loop actuator performance, closed loop torque and position control bandwidth, and torque and position tracking error during walking. The system is capable of producing up to 160 N-m of plantarflexion torque and 394 N of AP translation force with a closed loop control bandwidth of about 7 Hz in both degrees of freedom. Torque tracking during walking was accurate within about 10 N-m but position tracking was substantially affected by phase lag, possibly due to cable slack in the bidirectional mechanism. The prototype was capable of replicating our simulated prosthesis dynamics during gait and offers useful insights into the advantages and the practical considerations of using predictive biomechanical simulation as a design tool for wearable robots.

A Robotic Transtibial Prosthesis with Equilibrium-Adjustable Parallel Springs to Improve Energy Efficiency in Slope Walking

A Switching Control Strategy For Energy Efficient Walking On Uneven Surfaces

On the Design of a Powered Transtibial Prosthesis with Stiffness Adaptable Ankle and Toe Joints.

Walk the Walk: A Lightweight Active Transtibial Prosthesis

Metabolic Cost of Level-Ground Walking with A Robotic Transtibial Prosthesis Combining Push-Off Power and Nonlinear Damping Behaviors: Preliminary Results

Adaptive Slope Walking With a Robotic Transtibial Prosthesis Based on Volitional EMG Control

A Sagittal Planar Ankle-Foot Prosthesis with Powered Plantarflexion and Socket Alignment

Design, Optimization and Energetic Evaluation of an Efficient Fully Powered Ankle-Foot Prosthesis with a Series Elastic Actuator

Energy-Efficient Braking Torque Control of Robotic Transtibial Prosthesis

A Lightweight Powered Knee Prosthesis Replicating Early-Stance Knee Flexion During Level Walking

Improving Walking Energy Efficiency in Transtibial Amputees Through the Integration of a Low-Power Actuator in an ESAR Foot

Robotic Transtibial Prosthesis with Damping Control Improves Amputee'S Level-Ground Walking at Different Speeds

A Portable Variable Stiffness Unpowered Aided Exoskeleton Design

A Parallel Compliant Leg for Energy Efficient Walking of Exoskeleton–walker Systems

Optimal Design and Analysis of a Powered Ankle-Foot Prosthesis with Adjustable Actuation Stiffness

Design, Characterization, and Preliminary Assessment of a Two-Degree-of-Freedom Powered Ankle-Foot Prosthesis

Design Method and Verification of a Hybrid Prosthetic Mechanism with Energy-Damper Clutchable Device for Transfemoral Amputees

Gait-based Design and Human-machine Simulation of a Powered Hybrid Transfemoral Prosthetic Mechanism

ADDING PUSH-OFF POWER TO A ROBOTIC TRANSTIBIAL PROSTHESIS WITH NONLINEAR DAMPING BEHAVIORS

An Energy-Efficient Torque Controller Based On Passive Dynamics Of Human Locomotion For A Robotic Transtibial Prosthesis