Abstract:Superhydrophobic coatings with a rough structure and low surface energy have been regarded as new high-efficiency anti-dust solutions. However, current research on the anti-dust mechanism of superhydrophobic materials is still insufficient. Main obstacles are the difficulty in determining the contact state between the dust particle and the rough structure and calculating the contact force accurately. Herein, a new methodology that introduces rough surface discretization and extends the Johnson-Kendall-Roberts (JKR) model to solve the adhesive contact forces of a particle-rough surface was proposed. Further, the lattice Boltzmann method coupled with the JKR-based discrete element method was employed to study the particle deposition characteristics on superhydrophobic surfaces with randomly distributed rough structures. Surfaces with different rough structures were reconstructed using the fast Fourier transformation method. The particle-airflow and rough surface-airflow interactions were calculated using the immersed moving boundary method. The coupling models and computation scheme were validated by comparing the simulation results with those recorded by a high-speed camera. The effects of the particle diameter, airflow inlet velocity, surface energy, and surface structures (characterized by skewness, kurtosis and standard deviation) on particle migration, deposition morphology and deposition rate were compared and analyzed. The results indicate that smaller particles with larger velocities are less likely to be deposited on superhydrophobic surface. Increasing the surface energy of the rough surface can significantly enhance the particle deposition rate owing to the strong particle–surface adhesion force. Further, appropriate surface roughness can reduce particle–surface adhesion and particle energy dissipation during collision, thereby leading to a deposition reduction. However, excessive peaks and deep valleys on the rough surface would hinder the rolling and translation of the particles, thereby resulting in particle accumulation on the surface. Finally, using superhydrophobic surfaces with a skewness of 0 and kurtosis of approximately 5.0, and appropriately reducing the standard deviation of the rough-surface structures can significantly enhance the effect of superhydrophobic surfaces on anti-dust performance.

Enhancement of submicron particle deposition on a semi-circular surface in turbulent flow

Enhancement of particle collection efficiency considering the structural interplay: particle motion characteristics analysis

Simulation of Micron and Submicron Particle Trapping by Single Droplets with Electrostatic Fields

Investigation of particle deposition efficiency enhancement in turbulent duct air flow by surface ribs with hybrid-size ribs

Development and Experimental Investigation of the Narrow-Gap Coated Electrostatic Precipitator with a Shield Pre-Charger for Indoor Air Cleaning

Improve Removal Efficiency of PM 1 Depending on Collision Enhancement and Agglomeration Effect

Air Purification Study Based on the Adhesion Effect between Low-Curvature Liquid Surfaces and Air Convection Friction

Design, fabrication and characterization of three-dimensional patterned microstructured surfaces with self-cleaning properties from hydrophilic materials

Performance optimization of rectangular flat pleated filter with slit nozzle for dust cleaning

Ultrasonic Aerosol Agglomeration: Manipulation of Particle Deposition and Its Impact on Air Filter Pressure Drop

Enhancing the capturing characteristics of charged droplets on submicron particles: An experimental and numerical investigation

Agglomeration and Capture of Fine Particles in the Coupling Effect of Pulsed Corona Discharge and Acoustic Wave Enhanced by Spray Droplets

Systematic Approach to Optimization of Submicron Particle Agglomeration Using Ionic-Wind-Assisted Pre-Charger

Enhancement of vapor condensation heat transfer on the micro- and nano-structured superhydrophobic surfaces

Electrospun 3D Curly Electret Nanofiber Air Filters for Particulate Pollutants

Numerical Study of the Effect of Ventilation Pattern on Coarse, Fine, and Very Fine Particulate Matter Removal in Partitioned Indoor Environment

Numerical investigation of non-spherical particle deposition characteristics on filter media

Numerical methodology for simulating particle deposition on superhydrophobic surfaces with randomly distributed rough structures

Study on the key structure parameters of a gravity settling chamber based on a flow field simulation

Improved performance of the opposing pulsed-jet cleaning by annular-slit nozzles for pleated filter cartridges

An experimental study on the removal of submicron fly ash and black carbon in a gravitational wet scrubber with electrostatic enhancement