Abstract:The photovoltaic (PV) power plants' power generation is affected obviously by the cleanliness of the photovoltaic modules. The dust is the primary source causing the pollution. Natural dust deposition is affected by human activities and meteorological factors such as temperature, humidity, wind speed and PM10 concentration in the region where PV modules are installed. The research efforts so far have been focused on predicting PV power outputs, however, in the real operations the PV outputs can significantly deviate from the prediction due to the dust pollution which, unfortunately, has not been fully investigated. This paper, to the authors' best knowledge, is the first research to analyze the dust composition and evaluate its impacts on the PV power outputs with the real field test data in East China Collected through a series of experiments completed in the lab of the Institute of Distributed Generation and Microgrid, Zhejiang University of Technology, in East China. A PV output forecasting model was set up first based on the irradiance and the component's temperature. Then a complete meteorological and electrical data online monitoring system was developed for data acquisition. The morphology of the dust particles on the investigated photovoltaic modules was observed by a scanning electron microscope, and the composition of the dust particles was measured by X-ray fluorescence. The research found that the dust accumulated on the surface of photovoltaic modules tend to form clusters under the influence of rainfall which is one major cause on fast dropping PV outputs. The analysis shows the dust deposit mainly comprises of SiO2 and CaCO3. Further analysis indicates in East China, the average dust density on PV modules is 0.644 g/m(2) in a week and consequently the dust reduces the PV output power by 7.4% one week. The research is of significance not only in terms of giving the real-data based analysis on dust properties deposited on PV panels, but also on revealing the relationship between power output attenuation and dust deposition, which helps improve the PV power output prediction accuracy and develop efficient cleaning strategies for photovoltaic modules. (C) 2020 Published by Elsevier Ltd.

Microstructure of Surface Pollutants and Brush-Based Dry Cleaning of a Trough Concentrating Solar Power Station

Recent Progress of Dry Electrostatic Precipitation for PM 2 . 5 Emission Control from Coal-fired Boilers

Study on Impacts of Dust Accumulation and Rainfall on PV Power Reduction in East China

Study on Dust Deposition Mechanics on Solar Mirrors in a Solar Power Plant

Study on the influence of dust accumulation on the optical performance of trough solar concentrator under different rainfall intensities based on alpine areas

Review on dust deposition and cleaning methods for solar PV modules

Heliostat-field soiling predictions and cleaning resource optimization for solar tower plants

Development of Advanced Electrostatic Precipitation Technologies for Reducing PM2.5 Emissions From Coal-fired Power Plants

Particles Detection and Analysis of Hard Disk Substrate after Cleaning of Post Chemical Mechanical Polishing

Application of the Electrochemical Cleaning Method Before Solar Texturing of Solar Cells

Investigation on particle deposition criterion and dust accumulation impact on solar PV module performance

Improving the electrostatic precipitation removal efficiency on fine particles by adding wetting agent during the chemical agglomeration process

Investigation of the Dust Scaling Behaviour on Solar Photovoltaic Panels

Soiling impact and cleaning techniques for optimizing photovoltaic and concentrated solar power power production: A state-of-the-art review

Dust removal device for waterless solar photovoltaic panel

An experimental study on the removal of submicron fly ash and black carbon in a gravitational wet scrubber with electrostatic enhancement

Analysis of Threshold Conditions for Cementation of Soiling on PV Modules and Telescope Mirrors

Enhancement of submicron particle deposition on a semi-circular surface in turbulent flow

Purification Characteristics of Fine Particulate Matter Treated by a Self-Flushing Wet Electrostatic Precipitator Equipped with a Flexible Electrode.

Impact of Soiling Physicochemistry on Mirrors With CSP Applications at the Plataforma Solar Del Desierto De Atacama, Chile

Enhanced Electrostatic Dust Removal from Solar Panels Using Transparent Conductive Nano‐Textured Surfaces