Abstract:An on-site test method for thermal and optical performances of parabolic-trough (PT) loop for utility scale concentrating solar power (CSP) plant is proposed. This method is comprised of sequentially off focus and in-focus tests. The off-focus test is first conducted for thermal performance as that in a complete PT loop, the front (upstream) collectors are used to heat up the heat transfer fluid (HTF) flowing through the rear (downstream) off -focus ones (the test section) while being cooled by the ambient. The front-rear order is reversible to test all the collectors. The correlation between the heat loss and the absorber (outer surface)-ambient temperature difference of the collectors is obtained by fourth order polynomial data-fitting. Then, the in-focus test is carried out for optical performance, which is achieved based on the energy balance. The heat loss is calculated based on the correlation acquired in the off -focus test. The incident solar radiation, heat gain, cosine loss and end loss are calculated based on the meteorological data, experimental data, local time and astronomical conditions, respectively. Therefore, the optical performance, i.e. the optical efficiency, is readily achievable. The proposed test method was implemented on the 300 kWt experimental rig located in Langfang, Hebei, China. The optical efficiency is evaluated to be (70.77 +/- 1.08)%, which lies within the published range. On the other hand, a thermohydraulic model for the parabolic-trough collector (PTC) loop of the 300 kWt experimental rig was developed for system-level use. This model was incorporated with the optical efficiency obtained on the experimental rig. The good agreement between the simulation results and experimental data leads to the reciprocal verifications between the proposed on-site test method and the thermohydraulic model. (C) 2017 Elsevier Ltd. All rights reserved.

Study on the influence of dust accumulation on the optical performance of trough solar concentrator under different rainfall intensities based on alpine areas

Heat-collecting performance of linear Fresnel reflector concentrator measuring and forecasting after dust accumulation

Dust accumulation effect of glazing cover inner surface on the performance of transpired solar air collector

Microstructure of Surface Pollutants and Brush-Based Dry Cleaning of a Trough Concentrating Solar Power Station

Sunlight Concentration Effect Analysis of Lenses on Single-Slope Solar Still

Impacts of seasonal dust accumulation on a point-focused Fresnel high-concentration photovoltaic/thermal system

Design, Simulation and On-Sun Experiments of a Modified Sliding-Bed Particle Solar Receiver for Coupling with Tower Concentrating System

Influences of Optical Factors on the Performance of the Solar Furnace

Analysis of the influencing factors of the dust on the surface of photovoltaic panels and its weakening law to solar radiation — A case study of Tianjin

Study on Dust Deposition Mechanics on Solar Mirrors in a Solar Power Plant

PERFORMANCE STUDY OF A PARABOLIC TROUGH ONCENTRATOR-PHOTOVOLTAIC/THERMAL SYSTEM

A Detailed Parameter Study on the Comprehensive Characteristics and Performance of a Parabolic Trough Solar Collector System

Effects of particle sizes and tilt angles on dust deposition characteristics of a ground-mounted solar photovoltaic system

Analysis on an optimal transmittance of Fresnel lens as solar concentrator

A Detailed Study on the Effects of Sunshape and Incident Angle on the Optical Performance of Parabolic Trough Solar Collectors

Heliostat-field soiling predictions and cleaning resource optimization for solar tower plants

Concentration performance evaluation of sunlight concentrators: Fresnel lens, plano-convex lens, and parabolic mirrors for daylighting application

Theoretical analysis of error transfer from surface slope to refractive ray and their application to the solar concentrated collector

Reduction of Dust Deposition on Solar Photovoltaic Cells by Self‐Cleaning Coating: Experimental Study of Influencing Factors

Experimental investigation of the anti-soiling performances of different wettability of transparent coatings: Superhydrophilic, hydrophilic, hydrophobic and superhydrophobic coatings

An On-Site Test Method for Thermal and Optical Performances of Parabolic-Trough Loop for Utility-Scale Concentrating Solar Power Plant