Analysis of Thickness Distributions Calculated from Surface Strains Obtained through Digital Image Correlation for Incremental Sheet Forming

Marthe Vanhulst,Hans Vanhove,Yannick Carette,Stijn Waumans,Joost R. Duflou
DOI: https://doi.org/10.4028/p-14s93w
2022-07-23
Key Engineering Materials
Abstract:Publication date: 22 July 2022 Source: Key Engineering Materials Vol. 926 Author(s): Marthe Vanhulst, Hans Vanhove, Yannick Carette, Stijn Waumans, Joost R. Duflou This paper discusses the thickness distributions calculated from surface strain measurements using stereo Digital Image Correlations (DIC) for parts produced with Single Point Incremental Forming (SPIF). The research is carried out on six benchmark cones and pyramids with each convex, straight and concave walls. The accuracy of the thickness calculations, under the assumption of material incompressibility and using the formula for the Green-Lagrange strains, is compared to the thickness distributions measured with a fringe projection scanner. The thickness estimations based on the measured strains proved to be representative for the measured thickness distributions with a mean error of 0.0182 mm, which corresponds to a relative error of 1.47 % of the mean measured thickness. However, errors of up to 0.1688 mm were found in areas of high wall angles and curvatures, corresponding to a relative maximal error of 13.69 % of the mean measured thickness. Hence, the DIC measurements are well suited for characterizing the thickness. Using the thicknesses calculated from the DIC measurements to find the minimal thickness as an indicator of part failure, is possible with relative errors that have an average overestimation of 2.87% of the minimal measured thickness.
What problem does this paper attempt to address?