Abstract:This paper aims to clarify the mechanisms governing the calcination and sulfation of limestone during oxy-fuel combustion. Apart from pure limestone, the mixtures of limestone with a low-rank brown coal at three different mass ratios were combusted in an lab-scale drop-tube furnace (DTF) to systematically examine the influences of a number of single parameters, including gas composition (i.e. 27% O2/ 73% CO2 versus air), flame temperature, ash to limestone mass ratio and the concentration of SO2 in the furnace. The furnace temperature and nominal gas residence time were fixed at 1000C and 4 sec, respectively. The ash sample was collected through dry ice quenching, and analyzed by TGA to quantify the unreacted CaCO3 fraction, X-ray fluorescence spectroscopy (XRF) for elemental quantification and X-ray Diffraction Spectrometer (XRD) for the speciation of crystallized structures. The results indicate that, for the pure limestone, its calcination in 27% O2/73% CO2 was significantly inhibited by the large pressure of CO2, as expected. However, once coal is added with limestone together into the furnace, the fl ame formed by coal volatile oxidation outweighed the negative in fluence of CO2 partial pressure, accordingly, the limestone decomposition in 27% O2/73% CO2 was increased to the similar level with that observed in air, due to the same fl ame temperature confirmed in these two gases. The coal-bound fly ash also posed promoting effect on the decomposition of limestone, potentially through the initial formation of calcium alumino-silicate on the limestone surface, which was subsequently shed away by bulk gas. A fresh surface of limestone was thus exposed into bulk gas to continue decomposition or undergo sulfation. It was also confirmed that, the direct sulfation of limestone to CaSO4 played an important role on the sulfur capture in O2/CO2. Its reaction rate is slightly slower than the sulfation reaction of calcium oxide at the higher SO2 content in flue gas..

New Insight into Energy-Saving Calcination of Limestone: Preparation, Characterization, and Application of Partially Calcined Limestone

Utilization of Coal Gangue and Copper Tailings As Clay for Cement Clinker Calcinations

The Synergistic Effect of Calcained Coal-Series Kaolinite and Limestone on the Hydration of Portland Cement

Hydration Mechanism of Limestone Calcined Clay Cement Containing Calcined Coal Gangue

Recycling Sewage Sludge Ash and Limestone for Sustainable Cementitious Material Production

ZeroCAL: Eliminating Carbon Dioxide Emissions from Limestone's Decomposition to Decarbonize Cement Production

Exploratory study on fluidized calcination of limestone

Activation of Low-Quality Coal Gangue Using Suspension Calcination for the Preparation of High-Performance Low-Carbon Cementitious Materials: A Pilot Study

A study on the calcination and sulphation behaviour of limestone during oxy-fuel combustion

Study on Gas-Solid Heat Transfer and Decomposition Reaction of Calcination Process in an Annular Shaft Kiln Based on the Finite Volume Method

Oxyfuel Combustion Conference Mechanisms for Calcination and Sulfation of Limestone during Oxy-Fuel Combustion

Electrochemical Transformation of Limestone into Calcium Hydroxide and Valuable Carbonaceous Products for Decarbonizing Cement Production

The Utilization of Lime-Dried Sludge As Resource for Producing Cement

Electrochemical Transformation of Limestone into Portlandite and Valuable Carbonaceous Products

Experimental Study on the Performance of Lime-Based Low Carbon Cementitious Materials

Study Of Limestone Thermal Decomposition In O-2/Co2 Atmosphere

Effect of High Content Limestone Powder on Microstructure and Mechanical Properties of Cement-based Materials

Numerical Simulation Study of Gas-Solid Heat Transfer and Decomposition Processes of Limestone Calcined with Blast Furnace Gas in a Parallel Flow Regenerative Lime Kiln

Research on Limestone Calcined Clay Cement-Based Ultra-High Performance Concrete with High Cement Substitution: Mixture Design and Engineering Properties

Fabrication of Energy-Efficient Carbonate-Based Cementitious Material Using Sodium Meta-Aluminate Activated Limestone Powder

Decomposition Mechanism and Calcination Properties of Small-Sized Limestone at Steelmaking Temperature