Abstract:China's 2022 crude steel production soared to an impressive 1.018 billion tons, and steel slag constituted approximately 10% to 15% of this massive output. However, a notable hindrance to the comprehensive utilization of steel slag arises from the fact that it contains 10% to 20% of free calcium oxide (f-CaO), resulting in volume instability. To address this challenge, our study delved into the dynamic transformation of the interface between lime and slag, as well as the fluctuations in the dissolution rate of lime. An Electron Probe Micro Analyzer, equipped with an energy-dispersive spectrometer, was employed for the analysis. Our findings revealed that the configuration of the reaction interface between quicklime and slag underwent alterations throughout various phases of converter smelting. At a temperature of 1400 °C, several significant transformations occurred, including the formation of a CaO-FeO solid solution, (Ca, Mg, Fe) olivine, and low-melting point (Ca, Mg) silicate minerals. With the gradual reduction in FeO content, a robust and high-melting 2CaO·SiO2 layer emerged, generated through the interaction between CaO and (Ca, Mg, Fe) olivine. Furthermore, for lime with a particle size of 20 mm and a calcination rate of 0%, the thickest layer of 2CaO·SiO2 was observed after 120 s of dissolution in slag A2 at 1400 °C. Overall, the dissolution rates of lime with different particle sizes in slag A1 to A4 showed a gradual increase. On the other hand, the dissolution rates of lime with different calcination rates in slag A1 to A4 exhibited an initial increase, followed by a decrease, and then another increase. The formation of a high-melting point and continuous dense 2CaO·SiO2 layer during the dissolution process hindered the mass transfer between lime and slag.

Decomposition Mechanism and Calcination Properties of Small-Sized Limestone at Steelmaking Temperature

The Kinetic Mechanism of the Thermal Decomposition Reaction of Small Particles of Limestone at Steelmaking Temperatures

Advances in calcium carbonate thermal decomposition

Study on Gas-Solid Heat Transfer and Decomposition Reaction of Calcination Process in an Annular Shaft Kiln Based on the Finite Volume Method

Numerical Simulation Study of Gas-Solid Heat Transfer and Decomposition Processes of Limestone Calcined with Blast Furnace Gas in a Parallel Flow Regenerative Lime Kiln

Experimental Study on Calcination and Fragmentation Characteristics of Limestone in Fluidized Bed

Model and Parameter Study of Limestone Decomposition Reaction

Dissolution Behavior of Lime with Different Properties into Converter Slag

Attrition of limestone during fluidized bed calcination and sulfation

Characterization of the sulfation reactivity of limestones with different particle size in a large-capacity TGA

Decomposition Behavior of Limestone Powder in Converter Flue Gas: Effect of Fe‐Oxide Dust on Calcium Ferrite Formation

New Insight into Energy-Saving Calcination of Limestone: Preparation, Characterization, and Application of Partially Calcined Limestone

Limestone Calcination Kinetics in Microfluidized Bed Thermogravimetric Analysis (MFB-TGA) for Calcium Looping

Attrition Performance and Morphology of Limestone under Different Conditions in Fluidized Bed

Model on desulfurization characteristic of limestone particles

A Study of the Explosive Cracking and Wear Characteristics of Limestone

Study on the Calcination of Fine Limestone Powder at High Temperature

An Experimental Study on the Primary Fragmentation and Attrition of Limestones in a Fluidized Bed

Decomposition mechanism of lumpy dolomite particles

Limestone hydrogenation combined with reverse water–gas shift reaction under fluidized and iso -thermal conditions using MFB-TGA-MS

Dissolution Reactivity and Kinetics of Low-Grade Limestone for Wet Flue Gas Desulfurization