Abstract:The significance of backplane devices for ultra-high-resolution (UHR) display has increased with the recent development of augmented reality (AR) and virtual reality (VR) devices. Since the human visual resolution can distinguish up to 60 pixels per degree (PPD), the AR/VR device panel needs at least 3000 pixels per inch (PPI) to exceed the human retina resolution limit for clear display without screen effect. As a results, the unit pixel pitch of thin film transistor (TFT) for UHR display should be not only smaller than a few micrometers (~3 μm), TFT channel length should also be sub-micrometers level. In active matrix organic light emitting diode (AMOLED) display type, self-aligned top gate (SATG) TFT has been widely used as a planar backplane device structure because of its low parasitic capacitance and tolerance of illumination degradation caused by the light from emitting layer [1-2]. However, SATG TFT has fundamental disadvantages for device miniaturization due to its essentially required area of metallization region for reducing contact resistance and scaling limit of channel induced by carrier diffusion shrinking effective channel length. For this reason, we suggested a size tunable oxide channel VTFT structure that can achieve a high pixel density on account of structural benefit on device footprint. In this work, we fabricated amorphous indium gallium zinc oxide (a-IGZO) based VTFT. The previously published VTFT structure, channel length is determined by the thickness of spacer between source and drain electrodes [3]. Owing to spacer etching process, uneven backchannel roughness and high off current has become well-known issues of VTFT. On the contrary, the proposed VTFT structure has a controllability of effective channel aspect ratio because source and drain electrodes are able to be patterned by photolithography process. Furthermore, the parasitic capacitance is also relatively less than the formerly reported VTFTs controlled by inevitable thickness limit structurally due to the electrodes. To sum up, we not only realized the oxide channel VTFT that meets high performance for AR/VR display, but opened new application possibility to UHR electronic devices platform. Figure 1. (a) Schematic of the proposed VTFT (b) Transfer characteristic of VTFT Acknowledgement This work was supported by the Korea Evaluation Institute of Industrial Technology(KEIT) grant funded by the Korea government (MOTIE) (No. 2021-11-1283) References Kang, Dong Han, et al. "Self-aligned coplanar a-IGZO TFTs and application to high-speed circuits." IEEE electron device letters 32.10 (2011): 1385-1387. Wang, Guoying, et al. "8.3: High Stability Against Light and Heat Based on the Top Gate Self‐Aligned a‐IGZO TFTs under OLED Dislplay." SID Symposium Digest of Technical Papers. Vol. 49. 2018. Petti, Luisa, et al. "Flexible quasi-vertical In-Ga-Zn-O thin-film transistor with 300-nm channel length." IEEE Electron Device Letters36.5 (2015): 475-477. Figure 1

A Short-Channel TFT of Amorphous In–Ga–Zn–O Semiconductor Pixel Structure With Advanced Five-Mask Process

(Invited) Short Channel Coplanar Amorphous-Indium-Gallium-Zinc-Oxide Thin-Film Transistors on Polyimide Substrate for High Resolution Displays

Self-Aligned Amorphous Indium-Gallium-Zinc-Oxide Thin-Film Transistor Using A Two-Mask Process Without Etching-Stop Layer

Indium–Gallium–Zinc–Oxide Thin-Film Transistors Based on Homojunctioned Structure Fabricated with a Self-Aligned Process

Amorphous In–Ga–Zn–O Thin Film Transistor Current-Scaling Pixel Electrode Circuit for Active-Matrix Organic Light-Emitting Displays

Vertical Oxide Channel Thin Film Transistor for Ultra-High-Resolution Display

Tri‐Layer Heterostructure Channel of a‐IGZO/a‐ITZO/a‐IGZO Toward Enhancement of Transport and Reliability in Amorphous Oxide Semiconductor Thin Film Transistors

Thin Film Transistor Using Amorphous InGaZnO Films as Both Channel and Source/Drain Electrodes

Oxide TFT with multilayer gate insulator for backplane of AMOLED device

Amorphous IGZO TFT with High Mobility of ~70 cm2/Vs via Vertical Dimension Control using PEALD.

Amorphous IGZO Thin-Film Transistor Gate Driver in Array for Ultra-Narrow Border Displays

Comparative Study of Atomic Layer Deposited Indium-Based Oxide Transistors with a Fermi Energy Level-Engineered Heterojunction Structure Channel through a Cation Combinatorial Approach

15.2: Invited Paper: Atomic Layer Deposited Oxide Semiconductor Enabling High Mobility and Low Driving Voltage in TFTs

Compact Integration of Hydrogen–Resistant a–InGaZnO and Poly–Si Thin–Film Transistors

Amorphous indium–gallium–zinc–oxide thin-film transistors using organic–inorganic hybrid films deposited by low-temperature plasma-enhanced chemical vapor deposition for all dielectric layers

Implementation of oxide vertical channel TFTs with sub-150 nm channel length using atomic-layer deposited IGZO active and HfO2 gate insulator

Present status of amorphous In–Ga–Zn–O thin-film transistors

High Resolution Inkjet Printed Oxide Thin Film Transistors with Self-Aligned Fine Channel Bank Structure.

Highly robust oxide TFT with bulk accumulation and source/drain/active layer splitting

Self-Aligned Top-Gate Metal-Oxide Thin-Film Transistors Using a Solution-Processed Polymer Gate Dielectric

A Back-Channel-Etched Amorphous InGaZnO Thin-Film Transistor Technology with Al-Doped ZnO As Source/Drain and Pixel Electrodes