Abstract:Partially bonded rock anchors are crucial structural tunnel support elements whose effectiveness depends on their interactions with the surrounding rock. This study combined laboratory experiments and numerical simulations to examine the mechanical behavior of partially bonded rock anchors under pull-out tests, focusing on the influence of bonded lengths. The axial strain of the anchor body and the vertical strain of the concrete block along the anchor axis were tested using distributed optical fibers. The results indicated that the anchor body stress remained relatively constant in the unbonded sections but gradually decreased as the depth into the bonded section increased. Simultaneously, the significant compressive stress range induced by the rock anchor in the concrete block decreased rapidly as the bonded length increased. Subsequently, the effects of different bonded lengths, unbonded section positions, and bonding combinations on the mechanical behavior and support effectiveness of partially bonded rock anchors in highly stressed soft rock tunnels undergoing substantial deformation were investigated using numerical simulations in ABAQUS. These findings suggest that rock anchors with longer bonded lengths have better control of the rock between the anchors. Simultaneously, the maximum axial stress of rock anchors tended to increase with longer bonded lengths. The rock displacement tended to be obviously larger when the unbonded section was set at the end of the rock anchors compared with when the unbonded section was set in the middle. The rock displacement was larger when the unbonded section was set at the outer end of the rock anchors, indicating that setting unbonded sections near the tunnel wall was detrimental to controlling rock deformation while improving structural safety. Setting one unbonded section near the tunnel wall and another unbonded section in the middle of the rock anchors resulted in excellent structural safety and rock deformation control. Furthermore, fully bonded rock anchors were compared with partially bonded rock anchors based on suitable bonding combinations in the deformation section of Muzhailing Tunnel. The results indicated that the fully bonded rock anchors experienced axial forces exceeding the yielding load in the early stages of support, with noticeable early yielding of the anchor plate. In contrast, the unbonded sections in the partially bonded rock anchors did not yield in either the bonded anchor body or the anchor plate. Partially bonded rock anchors exhibited better overall stability and reliability under high-deformation tunnel conditions.

Expansion and Pull-Out Simulation Test of Self-expanding Bond Bolts in Adjacent Rock Bodies with Varied Stiffnesses

Field experimental study on the pull-out characteristics of a new type of expanding shell bolt

Enhanced finite element analysis of shear connector pull-out based on cohesive zone model

Study on reasonable anchorage length based on failure mechanism of the bolt anchorage system

Fatigue Deformation and Damage Characteristics of Bolting System under Stress-Controlled Cyclic Pullout

Bolt Pull-Out Tests of Anchorage Body under Different Loading Rates

Experimental and numerical study of large high strength bolt shear connector embedded in HFRC

Strengthening Device for Improving Shear Performance of Anchor Cable in Rock Support

Buckle Propagation of Sandwich Pipes under External Pressure

A Novel Numerical-Iterative-approach for Strain-Softening Surrounding Rock Incorporating Rockbolts Effectiveness and Hydraulic-Mechanical Coupling Based on Three-Dimensional Hoek-Brown Strength Criterion

Laboratorial Tests and Numerical Modeling of Rock Bolts Bonded by Different Materials

Analytical studying the axial performance of fully encapsulated rock bolts

Anchoring mechanical characteristics of Ductile-Expansion bolt

Pullout Performances of Grouted Rockbolt Systems with Bond Defects

A novel constitutive law of confined grouted rock bolt under pull-out load based on a fully nonlinear bond-slip model

Mechanical properties of partially bonded rock anchors in squeezing large-deformation soft rock tunnels

Effect of Multi-directional Restraint Induced by Reinforced Steel Bars on ASR Expansion and Bond Performance

Mechanical testing and numerical simulation of intelligent terminal structure of rockbolt used as a deformable support and for safety monitoring in rock engineering

Experimental Study of the Effects of Borehole Size, Borehole Roughness, and Installation Pressure on the Pull Load Capacity of Inflatable Rockbolts

THE PULL -OUT EXPERIMENT STUDY AND THEORITIAL ANALYSIS OF EXPANSION BUILDING ANCHORS IN CONCRETE

Research on dynamic stability of large deformation roadway with application of segmented resistance anchor bolt