Abstract:Rock strength is generally divided into the components of cohesion and internal friction. These components are two important parameters for estimating the damaged or disturbed zone around an excavation and its corresponding support design. However, the cohesive and frictional strength components at the same strain increment before peak strength are difficult to separate from each other. In addition, the misperception of their mutual evolution has been in existence for a long time. A numerical code, Rock Failure Process Analysis (RFPA2D), based on the finite element method was used in this study to clarify this misperception. The RFPA2D approach can account for rock heterogeneity and capture the entire rock failure process without prior assumptions regarding where and how microcracks and fracturing develop. Numerical models of rock were copied and reused in uniaxial and biaxial tests to create identical heterogeneous models for use under different confining stress conditions. Forty-five numerical tests (5 homogeneity indexes × 9 confining pressures) were used to calculate the results of the principal stresses (σ1 and σ3) at specified increments of axial strain. The intercept and the slope of a linear line fitting to the principal stresses at the same strain before peak strength were obtained in the principal stress space. The intercept is related to the cohesive strength component of the shear resistance, and the slope of the linear line is a pseudo-internal friction coefficient. Through the analysis of the linear fitting results, it has been found that the cohesive strength component increases while the pseudo-internal friction coefficient decreases with increasing homogeneity index of the numerical rock models. The values of cohesion and internal friction vary as a function of the strain state, and they are immediately activated with a strain increment before peak strength. The research results strengthen the understanding of the mobilization of the load-bearing capacity of rock mass surrounding an opening and can improve the design of practical support systems.

A Novel Numerical-Iterative-approach for Strain-Softening Surrounding Rock Incorporating Rockbolts Effectiveness and Hydraulic-Mechanical Coupling Based on Three-Dimensional Hoek-Brown Strength Criterion

Study Of Surrounding Rock Damage Induced By Tunnel Boring Machine Driving Tunnel At West Route Of South To North Water Transfer Project

Numerical solutions for strain-softening surrounding rock under three-dimensional principal stress condition

Numerical Simulation of Stone Column Replacement by Consecutive Dynamic Compaction in Soft Ground

A simple numerical procedure for the elasto-plastic coupling finite strain analysis of circular tunnels in strain-softening rock masses

A Numerical Stepwise Approach for Analysis of Cavity Expansion in Strain-Softening Rock or Soil Mass

A novel anisotropic deterioration mechanical model for rock ductile–brittle failure under 3D high-stress and its application

Coupled rheological behavior of tunnel rock masses reinforced by rock bolts based on the non-hydrostatic stress field

Strength and Failure Behaviors of a Jointed Rock Mass Anchored by Steel Bolts: A Numerical Modeling Study

An Elasto-Plastic Damage Model for Rocks Based on a New Nonlinear Strength Criterion

Development of a Unified Rock Bolt Model in Discontinuous Deformation Analysis

A New Numerical Finite Strain Procedure for a Circular Tunnel Excavated in Strain-Softening Rock Masses and Its Engineering Application

Numerical Simulation of the Interfacial Behaviour of Grouted Rockbolts in Tunnel Support Based on a Tri-Linear Bond-Slip Model

Nonlinear Visco-Elasto-Plastic Model for Surrounding Rock Incorporating the Effect of Intermediate Principal Stress

FE Analysis of Rock with Hydraulic-Mechanical Coupling Based on Continuum Damage Evolution

Numerical study of the evolution of cohesion and internal friction in rock during the pre-peak deformation process

Coupling Rheological Behavior of Rock Mass Supported with Rockbolts Based on the Point Load Model

Coupled analytical solutions for circular tunnels considering rock creep effects and time-dependent anchoring forces in prestressed bolts

A Strain-Softening Constitutive Model of Heterogeneous Rock Mass Considering Statistical Damage and Its Application in Numerical Modeling of Deep Roadways

A new three-dimensional rock strength criterion based on shape function in deviatoric plane

Analysis and numerical calculation of a coupled creep and strain-softening model for soft rock tunnels