Abstract:This thesis introduces a novel quadrotor manipulation system that consists of 2-link manipulator attached to the bottom of a quadrotor. This new system presents a solution for the drawbacks found in the current quadrotor manipulation system which uses a gripper fixed to a quadrotor. Unlike the current system, the proposed system has a 6-DOF, and it provides enough distance between the quadrotor and the object. System kinematics and dynamics are derived. To study the feasibility of the proposed system, a quadrotor with high enough payload to add the 2-link manipulator is constructed. Its parameters are identified to be used in the simulation and controller design. A CAD model is developed to calculate the mass and moments of inertia in an accurate way. Direct relationships between Pulse Width Modulation and each of the angular speeds, thrust forces, and drag moments of the rotors are identified. A Direction Cosine Matrix complementary filter is used to estimate the attitude of the quadrotor using the IMU measurements. Attitude stabilization controller is designed based on feedback linearization technique to test the identified parameters and the attitude estimation. The results of the experiments show satisfactory accuracy of the identified structure parameters, the identified rotor assembly parameters, and the attitude estimation algorithm. A controller for the proposed system is designed based on three control techniques: feedback linearization based PID control, direct fuzzy logic control, and fuzzy model reference learning control. These controllers are tested to provide system stability and trajectory tracking under the effect of picking and placing a payload and the effect of changing the operating region. Simulation results show that the fuzzy model reference learning control technique has superior performance. The results indicate the feasibility of the proposed system.

A Simple Six Degree-of-Freedom Aerial Vehicle Built on Quadcopters

A Minimal Thrust Vectoring Rotor with Six Degree of Freedom: Design and Analysis

TIE: an Autonomous and Adaptive Terrestrial-Aerial Quadrotor

A Modular Aerial System Based on Homogeneous Quadrotors with Fault-Tolerant Control

Development of a Full Orientation Flight Robotics: Dynamics Modeling, Analysis, and Control Design

Quadrotor Aircraft Design Based on the K60 Controller

Real-Time Implementation of Decoupled Controllers for Multirotor Aircrafts.

Modular Multi-Rotors: From Quadrotors to Fully-Actuated Aerial Vehicles

Modeling and Control of PADUAV: a Passively Articulated Dual UAVs Platform for Aerial Manipulation*

6-DOF All-Terrain Cyclocopter

Design, Modeling, and Control of a Coaxial Drone

Development and Application of a Novel High-Order Fully Actuated System Approach—Part I: 3-DOF Quadrotor Control

Minimally actuated tiltrotor for perching and normal force exertion

Dynamics Modeling and Trajectory Tracking Control of a Quadrotor Unmanned Aerial Vehicle

Modeling and Control of an Omnidirectional Hexrotor UAV with Tilted-Rotors

The ODQuad: Design and Experimental Validation of a Novel Fully-actuated Quadrotor

Lifting-wing Quadcopter Modeling and Unified Control

Quaternion-Based Sliding Mode Control for Six Degrees of Freedom Flight Control of Quadrotors

Novel Quadrotor Manipulation System

Design and Flight Control of a Novel Tilt-rotor Octocopter Using Passive Hinges

Collision-Free 6-DoF Trajectory Generation for Omnidirectional Multi-rotor Aerial Vehicle