Abstract:This thesis introduces a novel quadrotor manipulation system that consists of 2-link manipulator attached to the bottom of a quadrotor. This new system presents a solution for the drawbacks found in the current quadrotor manipulation system which uses a gripper fixed to a quadrotor. Unlike the current system, the proposed system has a 6-DOF, and it provides enough distance between the quadrotor and the object. System kinematics and dynamics are derived. To study the feasibility of the proposed system, a quadrotor with high enough payload to add the 2-link manipulator is constructed. Its parameters are identified to be used in the simulation and controller design. A CAD model is developed to calculate the mass and moments of inertia in an accurate way. Direct relationships between Pulse Width Modulation and each of the angular speeds, thrust forces, and drag moments of the rotors are identified. A Direction Cosine Matrix complementary filter is used to estimate the attitude of the quadrotor using the IMU measurements. Attitude stabilization controller is designed based on feedback linearization technique to test the identified parameters and the attitude estimation. The results of the experiments show satisfactory accuracy of the identified structure parameters, the identified rotor assembly parameters, and the attitude estimation algorithm. A controller for the proposed system is designed based on three control techniques: feedback linearization based PID control, direct fuzzy logic control, and fuzzy model reference learning control. These controllers are tested to provide system stability and trajectory tracking under the effect of picking and placing a payload and the effect of changing the operating region. Simulation results show that the fuzzy model reference learning control technique has superior performance. The results indicate the feasibility of the proposed system.

The ODQuad: Design and Experimental Validation of a Novel Fully-actuated Quadrotor

TIE: an Autonomous and Adaptive Terrestrial-Aerial Quadrotor

Disturbance observer-based quadrotor attitude tracking control for aggressive maneuvers

VID-Fusion: Robust Visual-Inertial-Dynamics Odometry for Accurate External Force Estimation

Novel Quadrotor Manipulation System

A Control Theoretic Study on Omnidirectional MAVs with Minimum Number of Actuators and No Internal Forces at Any Orientation

Experimental System Design of an Active Fault-Tolerant Quadrotor

System Design of a Novel Tilt-Roll Rotor Quadrotor UAV

A Modular Aerial System Based on Homogeneous Quadrotors with Fault-Tolerant Control

Development of a Full Orientation Flight Robotics: Dynamics Modeling, Analysis, and Control Design

Development and Application of a Novel High-Order Fully Actuated System Approach—Part I: 3-DOF Quadrotor Control

A Simple Six Degree-of-Freedom Aerial Vehicle Built on Quadcopters

Roller-Quadrotor: A Novel Hybrid Terrestrial/Aerial Quadrotor with Unicycle-Driven and Rotor-Assisted Turning

Design and Flight Demonstration of a Quadrotor for Urban Mapping and Target Tracking Research

Modeling and Control of an Omnidirectional Hexrotor UAV with Tilted-Rotors

Modular Multi-Rotors: From Quadrotors to Fully-Actuated Aerial Vehicles

Modelling, Analysis and Control of OmniMorph: an Omnidirectional Morphing Multi-rotor UAV

Variable-Pitch-Propeller Mechanism Design, and Development of Heliquad for Mid-flight Flipping and Fault-Tolerant-Control

Voliro: An Omnidirectional Hexacopter With Tiltable Rotors

Flying a Quadrotor with Unknown Actuators and Sensor Configuration

Design and implementation of a quadrotor for indoor swarm research