Abstract:In this article, the design process of a novel vibrating tool is presented to improve some key aspects of Single Point Incremental Sheet Forming (SPISF). The overall effect of a vibration assistance is an improvement of the process by decreasing certain constraints occurring during manufacturing (e.g., high forming forces, poor roughness and elastic springback). For developing such assistance, the objective of this study is to present the design methodology and characterization of an innovative tool. The horn-shape design of the tool is optimized to resonate at its natural frequencies in the 4–16 kHz frequency bandwidth. A frequency decoupling of the tool modes is obtained by a successful desymmetrization of the tool design to precisely control the vibration direction, focusing on axial, radial or coupled vibrating motion of the tool tip. Then, the unidirectional vibrating force generated by a piezoelectric actuator is transformed into a controlled multidirectional vibrating motion of the tool tip depending on the frequency and the amplitude of the actuator input signal. The core contribution of the paper is the design methodology itself of the forming tool, which encompasses a novel approach focused on the tool/sheet contact coupling analysis and its effect on the vibrating behavior of the tool during SPIF process conditions. All steps of the design methodology are described: from the design specifications to the prototype validation, including a finite element analysis and an experimental characterization of its modal behavior in free-end tool conditions as well as in different tool/sheet contact conditions through a simple indentation forming test inside an AA5086 metal sheet. Experimental results highlight the importance of considering process boundary conditions for modal identification and the influence of the vibration direction on the force reduction in forming conditions. A forming force reduction up to 26% is obtained exciting the bending mode of vibration of the presented forming tool identified in tool/sheet contact configuration, while reduction is less significant for the and bending modes.

Investigation of the ultrasonic vibration effect in incremental sheet metal forming process

Study on Metal Forming Patterns of the Ultrasonic Vibration Assisted Upset-extruding Process

Experimental Study of High-Frequency Vibration Assisted Micro/Mesoscale Forming of Metallic Materials

Ultrasonic vibration–assisted incremental sheet metal forming

Effects of superimposed high-frequency vibration on deformation of aluminum in micro/meso-scale upsetting

Acoustic softening and hardening of aluminum in high-frequency vibration-assisted micro/meso forming

Influence of ultrasonic vibration on forming force of 1060 aluminum sheet single point incremental forming

Microstructure Refinement by Tool Rotation-Induced Vibration in Incremental Sheet Forming

Experimental and Numerical Study of Forming Limit in 1060 Aluminum Ultrasonic Vibration Single Point Incremental Forming

Design and characterization of a vibrating tool for incremental sheet forming process

Research on Sheet Metal Digital Incremental Forming Technology without Support

Microstructural analysis of sheet hydroforming process assisted by radial ultrasonic punch vibration in a hydro-mechanical deep drawing die

Investigation of deviation and surface topography in ultrasonic vibration-assisted milling

Characteristics of 2D Ultrasonic Vibration Incremental Forming of a 1060 Aluminum Alloy Sheet

Effects of ultrasonic vibration on the residual stresses generated during single-point incremental forming

Experimental investigations of warm incremental sheet forming process on magnesium AZ31 and aluminium 6061 alloy

Investigation of Material Deformation Mechanism in Double Side Incremental Sheet Forming

The influence of post-annealing and ultrasonic vibration on the formability of multilayered Al5052/MgAZ31B composite

A review on the deformation mechanism and formability enhancement strategies in incremental sheet forming

Research on incremental forming simulation based on an improved constitutive model

Effects of forming parameters on the forming limit of single-point incremental forming of sheet metal