Abstract:The non-uniform corrosion of steel bars is the main factor affecting the durability of concrete. The cracking pattern of concrete due to corrosion is closely related to the distribution of the corrosion products. Research on the thickness distribution of the rust layer and the cracking pattern of concrete under different influencing factors is of great significance in the prediction of the service life of existing reinforced concrete structures and the avoidance of the premature cracking of the reinforced concrete structures to be built. This paper studies the thickness distribution of the rust layer on the surface of single and multiple corroded reinforcements under non-uniform corrosion. The electrochemical analysis of the electrified corrosion process was carried out by using the finite element analysis software, and the distribution of the current density was obtained. The effects of geometric parameters, steel bar position, and steel bar spacing and shape on the corrosion expansion cracking pattern were studied. The results indicated that as the position of the steel bar differed, the crack pattern of the concrete changed, depending on the number of corrosion peaks (i.e., the maximum thickness of the rust layer). In terms of the corner-located steel, the number of corrosion peaks varied in the cases of different geometrical parameters (i.e., the diameter of the steel bar and the distance between the steel bars and the stainless steel wire). Nevertheless, the critical corrosion degrees of the side-located and corner-located steel bars, with respect to the cracking of the outer concrete surface, were basically the same. Additionally, the ribbed steel bar presented a lower critical corrosion degree than that of the plain steel bar, while little influence was exhibited with the varying angles of the rib.

Local electrochemistry of reinforcement steel – Distribution of open circuit and pitting potentials on steels with different surface condition

Determination of Steady Critical Current Density of Hydrogen Evolution During Electrochemical Repair Process of Reinforced Concrete

EXPERIMENTAL STUDY OF PIEZOMAGNETISM OF PITTING CORROSIONSTEEL BARS UNDER TENSILE FORCE

Analysis of Polarization Curves Characteristics of Rebar in Concrete

Corrosion of Steel Embedded in Mortar and Concrete under Different Electrolytic Accelerated Corrosion Methods

A Self-Balanced Electrochemical Model for Corrosion of Reinforcing Steel Bar in Considering the Micro-Environments in Concrete

Non-uniform Corrosion of Steel in Mortar Induced by Impressed Current Method: an Experimental and Numerical Investigation

Study of Overprotective-Polarization of Steel Subjected to Cathodic Protection in Unsaturated Soil

A New Corrosion Sensor To Determine The Start And Development Of Embedded Rebar Corrosion Process At Coastal Concrete

Pitting corrosion and stress corrosion cracking study in high strength steels in alkaline media

Study on Experimental Method and Morphology of Accelerated Non-Uniform Corrosion of Steel Bars

Experimental study on stress detection of corroded steel bars based on piezomagnetic effect

Stainless steels: Passive film composition, pitting potentials, and critical chloride content in concrete

High throughput screening of localised and general corrosion in type 2205 duplex stainless steel at ambient temperature

Localized corrosion: Passive film breakdown vs. Pit growth stability, Part VI: Pit dissolution kinetics of different alloys and a model for pitting and repassivation potentials

The Critical Pitting Chloride Concentration of Various Stainless Steels Measured by an Electrochemical Method

Electrochemical Detection for the Corrosion of Reinforcing Steel in Concrete During Immersion and Drying Cycles

Rust Distribution of Non-Uniform Steel Corrosion Induced by Impressed Current Method

Pitting Corrosion Behaviour of New Corrosion-Resistant Reinforcement Bars in Chloride-Containing Concrete Pore Solution

Evaluating the stray current corrosion of steel rebar in different layouts

On the Impact of Cathodic Polarization on the Chloride Threshold of Carbon Steel in Alkaline Solutions