Abstract:U is a long-lived radioactive isotope with a half-life of 2.342(3) ×10 a, which produced principally by thermal neutron capture on U. U is potentially applied in geological research and nuclear safeguards. Accelerator mass spectrometry (AMS) is presently the most sensitive technique for the measurement of U. A method for AMS measurement of long-lived heavy ion U was developed at CIAE with the set up the AMS dedicated injector and the newly proposed PbO2 molecular ions for the simulation of U ion transport. A sensitivity of lower than 10 has been achieved for isotopic ratio U/U in present work. INTRODUCTION U is a long-lived radioactive isotope with a half-life of 2.342(3) ×10 a, mainly produced by the thermal neutron induced U(n,γ) U reaction. The isotopic ratio of U/U in nature is about 10, depending strongly on the integral thermal neutron flux received by the material. This makes U usable as an integrating neutron monitor over the last 100 million years [1], and potentially applicable in geological research [2]. The isotopic ratio of U/U could also be used as a “fingerprint” for indicating the presence of neutronirradiated uranium usually originated from nuclear activities [3]. Recently, several efforts have been made to measure U in environmental samples using techniques based on mass spectrometry such as high-resolution inductively coupled plasma spectrometry (HR-ICPMS), thermal ionization mass spectrometry (TIMS) and accelerator mass spectrometry (AMS). However, detection limits with conventional mass spectroscopy for U/U are ~10, leading to errors larger than 50% for uranium ore samples[4, 5]. Therefore the measurement of natural U is difficult or even impossible without AMS. AMS offers significant advantages over conventional mass spectroscopic methods in high sensitivity, smaller sample size, relatively free from isomer and molecular-ion interferences, and shorter measurement time. AMS measurement of actinides was presented firstly by IsoTrace facility X.L. Zhao et al. of Toronto group [6], in which the U/U is lower than 5×10 in a natural uranium ore from Cigar Lake deposit in Canada. The natural U/U has also been measured by several other groups, such as: VERA [7], ANU [8], LLNL [9], ANSTO [10], Munich [11], ETH [12] and Israel Weizmann Institute [13]. In this paper, a method for AMS measurement of longlived heavy ion U developed on the HI-13 Accelerator at China Institute of Atomic Energy (CIAE) is reported. The unique features include establishing of the AMS dedicated injector and the newly proposed PbO2 molecular ions for the simulation of U ion transport. THE AMS DEDICATED INJECTOR There is a general rule in AMS that a high mass resolution analyzer is needed to separate the neighboring interference and a high energy resolution analyzer is required to clip the tail of the high energy. The original injector setup at CIAE [14] with the mass resolution of M M Δ ~220, could not satisfy the requirement for AMS measurement of heavy isotopes (e.g., U, Hf, Sm). Therefore, a high resolution dedicated injector for AMS was developed, as shown in Fig. 1. The new injector adopts achromatic technique, which consists of a 90o electrostatic analyzer (ESA) and a 112o double-focusing analyzing magnet (MA). A triplet electric quadruple lens and a single electric quadruple lens were mounted at the entrance and the exit of the ESA beam line, respectively, for ions focusing. This spherical 90o ESA with 750 mm radius, has maximum electric field strength of 4 kV/cm and provides both horizontal and vertical focusing. The 112o double-focusing MA with a bending radius of 800 mm, has a maximum magnetic field of 1.3 T. The energy resolution of the electrostatic deflector

Study of charged particle activation analysis (I): determination sensitivity for single element samples

Sensitivity of charged particle activation analysis for long-lived radioactive nuclide determination

Simultaneous quantification of Zr, Cr and Cu in copper alloy matrix using charged particle activation analysis

Accelerator mass spectrometry for long-lived heavy ion 236 u at ciae *

Emulsion Cloud Chamber technique to measure the fragmentation of a high-energy carbon beam

Determination of concentrations of trace elements in nuclear grade graphite by charged particle activation analysis

Effect of large-angle incidence on particle identification performance for light-charged ($Z \le 2$) particles by pulse shape analysis with a pad-type nTD silicon detector

Measurement of 107-MeV proton-induced double-differential thick target neutron yields for Fe, Pb, and Bi using a fixed-field alternating gradient accelerator at Kyoto University

Charge-Changing Cross Sections of Ne-30, Na-32,Na-33 with A Proton Target

Assessment of photon and proton-induced activation in particles accelerators

A new Am-Be PGNAA setup for element determination in aqueous solution

Evaluating optimal quality assurance and quality control conditions of activation measurements at the accelerator-based boron neutron capture therapy system employing a lithium target

Development of fast-response PPAC with strip-readout for heavy-ion beams

Measurement of the production branching ratios following nuclear muon capture for palladium isotopes using the in-beam activation method

Comparison of two analysis methods for nuclear reaction measurements of 12C +12C interactions at 95 MeV/u for hadrontherapy

Cross section measurement of alpha particle induced nuclear reactions on natural cadmium up to 52 MeV

Efficiency of Position Sensitive PPAC for Various Ions

Photon Activation Analysis: a Proof of Principle Using a NIST Sediment Standard and an Electron Accelerator at Rensselaer Polytechnic Institute

Energy resolution improvement in simplified alpha spectroscopy for radionuclidic purity tests on 225Ac production floors

Comparative Analysis of Single Charged Particle Production in Proton-Carbon Interactions at High Energies

Spallation and fragmentation cross sections for 168 MeV/nucleon Xe136 ions on proton, deuteron, and carbon targets