Abstract:BackgroundCopper (Cu) and zinc (Zn) are essential cofactors of enzymes involved in several metabolic processes required for the development of tissue structures and immune response, especially in pediatrics and pregnant women. Triple quadrupole inductively coupled plasma mass spectrometer (ICP-QQQ) enables simultaneous precise quantification of multiple elements with high throughput, sensitivity, and specificity. Samples are introduced into ICP-QQQ as a liquid and converted to fine aerosol with the help of a nebulizer and spray chamber. The precision and sensitivity of measured metals are dependent on the sample preparation thus, this study focuses on comparing the analytical performances between two sample preparations: 0.5% nitric acid (HNO 3 ) as the only diluent (Diluent A) versus a combination of 0.5% HNO 3 along with 1% ethanol, 0.5% Ammonium hydroxide, 0.02% TritonX-100, and 0.1% HNO 3 (Diluent B) for Cu and Zn metal analysis in serum using ICP-QQQ.MethodsTwenty deidentified randomly selected patient serum samples were prepared with either diluent A or diluent B and analyzed by ICP-QQQ (Agilent 8900). Data were analyzed using EP Evaluator. Bland-Altman analysis was used to determine the agreement between the two sample preparations. Deming regression analysis was used to determine other analytical performances, such as the proportional and constant bias of Zn and Cu concentration.ResultsThere was a bias of -4.8 and -3.0 between the two sample preparation methods when analyzing Cu and Zn, respectively. The mean of Cu-Diluent B versus Cu—Diluent A was 125.2 ± 28.3 μg/dL and 120.4 ± 29.8 μg/dL, respectively, with a slope of 1.070. Conversely, the Zn comparison study shows a lower slope (0.769) with a mean of 71.0 ± 20.5 and 68.0 ± 16.1 μg/dL for Zn-Diluent B and Zn-Diluent A, respectively.ConclusionsSamples prepared with nitric acid solution only (Diluent A) appeared to show negative bias compared to Diluent B solution containing triton-X for both metals. However, the bias is within the total allowable error for zinc and copper. Importantly, Zn-sample analysis with diluent A (HNO 3 only) shows a 23% proportional bias, which is absent with copper sample analysis. A larger study is needed to further compare several methods of sample preparation in ICP-QQQ analysis while leveraging simple preparation without compromising analytical sensitivity. Overall, this study shows that both methods of sample preparation can be effectively used in the ICP-QQQ analysis of serum copper and zinc.

Simultaneous quantification of Zr, Cr and Cu in copper alloy matrix using charged particle activation analysis

Study of charged particle activation analysis (I): determination sensitivity for single element samples

Sensitivity of charged particle activation analysis for long-lived radioactive nuclide determination

Determination of concentrations of trace elements in nuclear grade graphite by charged particle activation analysis

Determination of analytes at trace level in uranium matrix by ICP-AES without chemical/physical separation

Standardization of Proton Induced X-Ray Emission for Analysis of Trace Elements in Thick Targets

Optimization and Applications of Instrumental and Preconcentration Neutron Activation Analysis Methods for Rapid Determination of Selected REE by Utilizing their Short‐Lived Activation Products

Co-precipitation approach to measure amount of $^{238}$U in copper to sub-ppt level using ICP-MS

MCNP simulation and experimental study in situ low-grade copper analysis based on PGNAA

Copper Isotope Compositions Measured Using a Sapphire Dual Path MC-ICPMS with a Collision/Reaction Cell

Photon Activation Analysis: a Proof of Principle Using a NIST Sediment Standard and an Electron Accelerator at Rensselaer Polytechnic Institute

An eco-friendly, sensitive and selective derivative spectrophotometric method for simultaneous determination of copper and zinc in synthetic mixtures, alloys and environmental samples

Application of chemically modified probe-atomic absorption spectrometry (CMPAAS)-I. Determination of Bi in copper alloy and lead by trioctylphosphine oxide-coated tungsten probe-AAS

Micro X-ray fluorescence (μ-XRF) methodology for quantitative elemental imaging of Al-Zn-Mg-Cu alloys with varying chemical compositions

Evaluating Nondestructive Quantification of Composition Gradients in Metal-Organic Frameworks by MeV Ion Microbeam Analysis

Matrix Effect In Quantitative Auger Analysis Of Binary-Alloys - Comparison Between The Measured And The Calculated Values

Development of analytical method for zirconium determination in U–Pu–Zr alloy samples

Improvements in Cu–Zn Isotope Analysis with MC-ICP-MS: A Revisit of Chemical Purification, Mass Spectrometry Measurement and Mechanism of Cu/Zn Mass Bias Decoupling Effect

B-164 Comparison of Analytical Performance of Two Processing Methods for Measurement of Zinc and Copper on Triple Quadrupole Inductively Coupled Plasma Mass Spectrometer

A new, simple and precise method for measuring cyclotron proton beam energies using the activity vs. depth profile of zinc-65 in a thick target of stacked copper foils

Simultaneous determination of lead, nickel, tin and copper in aluminium-base alloys using slurry sampling by electrical discharge and multielement ETAAS