Abstract:U is a long-lived radioactive isotope with a half-life of 2.342(3) ×10 a, which produced principally by thermal neutron capture on U. U is potentially applied in geological research and nuclear safeguards. Accelerator mass spectrometry (AMS) is presently the most sensitive technique for the measurement of U. A method for AMS measurement of long-lived heavy ion U was developed at CIAE with the set up the AMS dedicated injector and the newly proposed PbO2 molecular ions for the simulation of U ion transport. A sensitivity of lower than 10 has been achieved for isotopic ratio U/U in present work. INTRODUCTION U is a long-lived radioactive isotope with a half-life of 2.342(3) ×10 a, mainly produced by the thermal neutron induced U(n,γ) U reaction. The isotopic ratio of U/U in nature is about 10, depending strongly on the integral thermal neutron flux received by the material. This makes U usable as an integrating neutron monitor over the last 100 million years [1], and potentially applicable in geological research [2]. The isotopic ratio of U/U could also be used as a “fingerprint” for indicating the presence of neutronirradiated uranium usually originated from nuclear activities [3]. Recently, several efforts have been made to measure U in environmental samples using techniques based on mass spectrometry such as high-resolution inductively coupled plasma spectrometry (HR-ICPMS), thermal ionization mass spectrometry (TIMS) and accelerator mass spectrometry (AMS). However, detection limits with conventional mass spectroscopy for U/U are ~10, leading to errors larger than 50% for uranium ore samples[4, 5]. Therefore the measurement of natural U is difficult or even impossible without AMS. AMS offers significant advantages over conventional mass spectroscopic methods in high sensitivity, smaller sample size, relatively free from isomer and molecular-ion interferences, and shorter measurement time. AMS measurement of actinides was presented firstly by IsoTrace facility X.L. Zhao et al. of Toronto group [6], in which the U/U is lower than 5×10 in a natural uranium ore from Cigar Lake deposit in Canada. The natural U/U has also been measured by several other groups, such as: VERA [7], ANU [8], LLNL [9], ANSTO [10], Munich [11], ETH [12] and Israel Weizmann Institute [13]. In this paper, a method for AMS measurement of longlived heavy ion U developed on the HI-13 Accelerator at China Institute of Atomic Energy (CIAE) is reported. The unique features include establishing of the AMS dedicated injector and the newly proposed PbO2 molecular ions for the simulation of U ion transport. THE AMS DEDICATED INJECTOR There is a general rule in AMS that a high mass resolution analyzer is needed to separate the neighboring interference and a high energy resolution analyzer is required to clip the tail of the high energy. The original injector setup at CIAE [14] with the mass resolution of M M Δ ~220, could not satisfy the requirement for AMS measurement of heavy isotopes (e.g., U, Hf, Sm). Therefore, a high resolution dedicated injector for AMS was developed, as shown in Fig. 1. The new injector adopts achromatic technique, which consists of a 90o electrostatic analyzer (ESA) and a 112o double-focusing analyzing magnet (MA). A triplet electric quadruple lens and a single electric quadruple lens were mounted at the entrance and the exit of the ESA beam line, respectively, for ions focusing. This spherical 90o ESA with 750 mm radius, has maximum electric field strength of 4 kV/cm and provides both horizontal and vertical focusing. The 112o double-focusing MA with a bending radius of 800 mm, has a maximum magnetic field of 1.3 T. The energy resolution of the electrostatic deflector

Sensitivity of charged particle activation analysis for long-lived radioactive nuclide determination

Study of charged particle activation analysis (I): determination sensitivity for single element samples

Accelerator mass spectrometry for long-lived heavy ion 236 u at ciae *

Determination of Cross Sections for The238u(n,3n)

Simultaneous quantification of Zr, Cr and Cu in copper alloy matrix using charged particle activation analysis

Concurrent spectrometry of annihilation radiation and characteristic gamma-rays for activity assessment of selected positron emitters

Measurement of the production branching ratios following nuclear muon capture for palladium isotopes using the in-beam activation method

A new Am-Be PGNAA setup for element determination in aqueous solution

Determination of cross-sections of natPb(p,x)207Bi and natPb(p,x)194Hg by GeTHU

<SUP>12</SUP>C(p, p)<SUP>12</SUP>C Reaction (<i>E<sub>p</sub></i>=19.5-30 MeV) for Active Interrogation of Special Nuclear Material

Evaluating optimal quality assurance and quality control conditions of activation measurements at the accelerator-based boron neutron capture therapy system employing a lithium target

Development of an alpha-particle imaging detector based on a low radioactivity micro-time-projection chamber

A Detection System for Charged-Particle Decay Studies with a Continuous-Implantation Method

Cross section measurement of alpha particle induced nuclear reactions on natural cadmium up to 52 MeV

Characterization of the $^{12}$C(p,p')$^{12}$C Reaction ($E_p$=19.5--30 MeV) for Active Interrogation

Assessment of photon and proton-induced activation in particles accelerators

Mass spectrometry for the determination of fission products 135Cs, 137Cs and 90Sr: A review of methodology and applications

Sensitivity analysis towards trace-uranium detection with $γ$-$γ$ coincidence NAA

Production Cross Sections of 102mrh and 108mag in Proton Bombed Natpb Target with 400 MeV Energy

Measurement of 90Sr radioactivity in cesium hot particles originating from the Fukushima Nuclear Power Plant Accident