Abstract:It has recently been shown that solid-state nanometer-scale pores ('nanopores') can be used as highly sensitive single-molecule sensors. For example, electrophoretic translocation of DNA, RNA and proteins through such nanopores has enabled both detection and structural analysis of these complex biomolecules. Control over the nanopore size is critical as the pore must be comparable in size to the analyte molecule in question. The most widely used fabrication methods are based on focused electron or ion beams and thus require (scanning) transmission electron microscopy and focused ion beam (FIB) instrumentation. Even though very small pores have been made using these approaches, several issues remain. These include the requirement of being restricted to rather thin, mechanically less stable membranes, particularly for pore diameters in the single-digit nanometer range, lack of control of the surface properties at and inside the nanopore, and finally, the fabrication cost. In the proof-of-concept study, we report on a novel and simple route for fabricating metal nanopores with apparent diameters below 20 nm using electrodeposition and real-time ionic current feedback in solution. This fabrication approach inserts considerable flexibility into the kinds of platforms that can be used and the nanopore membrane material. Starting from much larger pores, which are straightforward to make using FIB or other semiconductor fabrication methods, we electrodeposit Pt at the nanopore interface while monitoring its ionic conductance at the same time in a bi-potentiostatic setup. Due to the deposition of Pt, the nanopore decreases in size, resulting in a decrease of the pore conductance. Once a desired pore conductance has been reached, the electrodeposition process is stopped by switching the potential of the membrane electrode and the fabrication process is complete. Furthermore, we demonstrate that these pores can be used for single-biomolecule analysis, such as that of λ-DNA, which we use in a proof-of-concept study. Importantly, our approach is applicable to single nanopores as well as nanopore arrays, and can easily be extended to deposits of metal other than Pt.

Three-dimensional structures of magnesium nanopores

Probing Chemical Structures and Physical Processes with Nanopores

Tailored Fabrication of 3D Nanopores with Dielectric Oxides for Multiple Nanoscale Applications

Characterization and Investigation of the Deformation Behavior of Porous Magnesium Scaffolds with Entangled Architectured Pore Channels.

Direct Fabrication of Atomically Defined Pores in MXenes

De Novo Design of Transmembrane Nanopores

Direct Fabrication of Atomically Defined Pores in MXenes Using Feedback‐Driven STEM

Fabrication and practical applications of molybdenum disulfide nanopores

Integrating Sub-3 Nm Plasmonic Gaps into Solid-State Nanopores

Fabrication and Applications of Solid-State Nanopores

Fabrication of Hourglass-Shaped Solid-State Nanopores

Controlled Deformation of Si3N4nanopores Using Focused Electron Beam in a Transmission Electron Microscope

Far-field, near-field and photothermal response of plasmonic twinned magnesium nanostructures

Tunable Architecture of Mg3p2 Microstructures

Sub-20 nm Nanopores Sculptured by a Single Nanosecond Laser Pulse

Photothermally Assisted Thinning of Silicon Nitride Membranes for Ultrathin Asymmetric Nanopores.

Development of Solid-State Nanopore Fabrication Technologies

The Mechanism of Three-Dimensional Manganese-Based Nanoporous Structure Formation by Laser Deposition Coupled with Dealloying

Precise electrochemical fabrication of sub-20 nm solid-state nanopores for single-molecule biosensing

Design of metal-organic frameworks for improving pseudo-solid-state magnesium-ion electrolytes: Open metal sites, isoreticular expansion, and framework topology

Nanoengineering Multilength Scale Porous Hierarchy in Mesoporous Metal-Organic Framework Single Crystals