Abstract:Advancement in adhesion technology has improved the development of wall-climbing robots. But there are still some challenges in the optimization of high adhesion strength bioinspired adhesives. Most of the traditional wall-climbing robot feet use vacuum suction and magnetic suction, which require smooth contact surfaces and magnetic permeability respectively, and their application scenarios are greatly limited. Therefore, new biomimetic adsorption methods need to be developed. Adhesives in air, inspired by geckos and spiders and other climbing animals in nature, adhere to the opposite surfaces using van der Waals forces. The biofiber-dried adhesives have a tree-like hierarchy: on the surface of the animal’s foot has a thin film of arrays of microfibers, each is divided into smaller arrays of submicron fibers. These nanosized fibril can bind tightly to opposite surfaces to induce van der Waals interactions. The van der Waals forces cause these nanosized fibril arrays to bind tightly to surfaces. Bionic studies based on gecko and spider adhesion mechanism has become a fierce research subject in the past few years. Previous studies have confirmed that finer contact structures produce higher adhesion. The influence of tip shape on the performance of adhesives of single fiber and fiber array is also a focus of research. In this work, in order to enhance the adhesion of biomimetic materials, patterned surfaces with micro-columns with different tip shapes are prepared by lithography and micromolding methods. We measured their normal adhesion and compared with flat contact surface. Micro pattern surface was found to be better than flat surface smooth. Different shape has a significant effect on adhesive force. A prestressing force of adhesive force and dependency has been identified and that is a key to obtain the adhesion force, which can provide the possibility to expand the application scenarios of wall-climbing robots and exists many potential applications from wall-climbing robots to bionic patches.

Hybrid electrostatic and elastomer adhesion mechanism for wall climbing robot

A gecko inspired fluid driven climbing robot

Design, fabrication and characterization of gecko inspired micro-fibrillar adhesive materials for wall climbing robots

Research on a wall climbing robot based on electrostatic adhesion

Design of Permanent Magnetic Wheel-Type Adhesion-Locomotion System for Water-Jetting Wall-Climbing Robot

Design and Performance Analysis of a Tracked Wall-Climbing Robot for Ship Inspection in Shipbuilding

Wet Adhesion Inspired Bionic Climbing Robot

Design analysis of electro-adhesive mechanism for wall-climbing robot

The Problem of Adhesion Methods and Locomotion Mechanism Development for Wall-Climbing Robots

A Biomimetic Wheel-Track Wall-Climbing Robot Based on Rolling Adsorption Mechanism

Design and Development of Wall Climbing Robot

Synergy Between Soft Feet and an Active Tail to Enhance the Climbing Ability of a Bio-inspired Climbing Robot

An insect-inspired wall-climbing robot using capillary adhesion

A Spiny Climbing Robot with Dual-Rail Mechanism

Design and motion planning of an autonomous climbing robot with claws

Design of a Curved Surface Adaptive Permanent Magnet Wall Climbing Robot

A flexible under-driven bionic climbing robot design

Electrically programmable adhesive hydrogels for climbing robots

Switchable Adhesion Actuator for Amphibious Climbing Soft Robot

Flexible Control and Coupling of Adhesion and Friction of Gecko Setal Array During Sliding

Development of a wheeled wall‐climbing robot with an internal corner wall adaptive magnetic adhesion mechanism