Abstract:Advancement in adhesion technology has improved the development of wall-climbing robots. But there are still some challenges in the optimization of high adhesion strength bioinspired adhesives. Most of the traditional wall-climbing robot feet use vacuum suction and magnetic suction, which require smooth contact surfaces and magnetic permeability respectively, and their application scenarios are greatly limited. Therefore, new biomimetic adsorption methods need to be developed. Adhesives in air, inspired by geckos and spiders and other climbing animals in nature, adhere to the opposite surfaces using van der Waals forces. The biofiber-dried adhesives have a tree-like hierarchy: on the surface of the animal’s foot has a thin film of arrays of microfibers, each is divided into smaller arrays of submicron fibers. These nanosized fibril can bind tightly to opposite surfaces to induce van der Waals interactions. The van der Waals forces cause these nanosized fibril arrays to bind tightly to surfaces. Bionic studies based on gecko and spider adhesion mechanism has become a fierce research subject in the past few years. Previous studies have confirmed that finer contact structures produce higher adhesion. The influence of tip shape on the performance of adhesives of single fiber and fiber array is also a focus of research. In this work, in order to enhance the adhesion of biomimetic materials, patterned surfaces with micro-columns with different tip shapes are prepared by lithography and micromolding methods. We measured their normal adhesion and compared with flat contact surface. Micro pattern surface was found to be better than flat surface smooth. Different shape has a significant effect on adhesive force. A prestressing force of adhesive force and dependency has been identified and that is a key to obtain the adhesion force, which can provide the possibility to expand the application scenarios of wall-climbing robots and exists many potential applications from wall-climbing robots to bionic patches.

An insect-inspired wall-climbing robot using capillary adhesion

Wet Adhesion Inspired Bionic Climbing Robot

Inverted and Inclined Climbing Using Capillary Adhesion in a Quadrupedal Insect-Scale Robot

A gecko inspired fluid driven climbing robot

Design, fabrication and characterization of gecko inspired micro-fibrillar adhesive materials for wall climbing robots

A Biomimetic Wheel-Track Wall-Climbing Robot Based on Rolling Adsorption Mechanism

Hybrid electrostatic and elastomer adhesion mechanism for wall climbing robot

An Aerial-Wall Robotic Insect That Can Land, Climb, and Take Off from Vertical Surfaces

A Biomimetic Adhesive Disc for Robotic Adhesion Sliding Inspired by the Net-Winged Midge Larva

Snail-inspired water-enhanced soft sliding suction for climbing robots

Vertical Climbing Locomotion Of A New Gecko Robot Using Dry Adhesive Material

Surface-Tension-Driven Biologically Inspired Water Strider Robots: Theory and Experiments

A Pressing Attachment Approach for a Wall-Climbing Robot Utilizing Passive Suction Cups

Impact of Confined Liquid Thin Film Upon Bioadhesive Force Between Insect Pads and Smooth Solid Surface

A miniaturized wall-climbing segment robot inspired by caterpillar locomotion

Switchable Adhesion Actuator for Amphibious Climbing Soft Robot

A Novel Wall Climbing Robot Based on Bernoulli Effect

Research on a wall climbing robot based on electrostatic adhesion

Frictional Adhesion of Patterned Surfaces and Implications for Gecko and Biomimetic Systems.

A Four-legged Wall-climbing Robot with Spines and Miniature Setae Array Inspired by Longicorn and Gecko

Mini Review: Comparison of Bio-Inspired Adhesive Feet of Climbing Robots on Smooth Vertical Surfaces