Abstract:An incremental analog-to-digital converter (I-ADC) with chopper stabilization (CHS) and self-calibration techniques is presented to meet the requirements of high resolution,low power consumption and small area for measuring devices of ultra-low-frequency signals.The I-ADC has the function of reset operation to avoid pattern noise caused by ultra-low-frequency signals.A first-order architecture is adopted for the I-ADC to reduce power consumption and chip area,and to achieve 14-bit resolution by increasing certain conversion time.The chopper stabilization technique is employed to eliminate the influence of amplifier's low-frequency noise and offset on the I-ADC's precision,and power-on self-calibration is employed to eliminate the systematic offset of the I-ADC.The circuit of the I-ADC and the layout of the modulator are designed with the DongBu 0.5 μm BCD technology.Simulation results in an input range of -156.25～156.25 mV show that the maximum absolute conversion error of the I-ADC is 21 μV,the maximum errors of differential nonlinearity and integral nonlinearity are 0.12 and 0.21 bit,respectively,and the average current consumption of the modulator is only 20 μA.The modulator occupies a chip area of only 150 μm × 310 μm.The proposed I-ADC achieves 14 bit resolution,which is required by ultra-low-frequency signal measuring systems,such as lithiumion battery coulometer,and has significant advantages of low power consumption and small area.

An area-efficient and high speed multiplexer for battery monitor system

Design and implementation of a multifunctional management chip for multi-cell Li-ion batteries in series

Design of High Voltage Multiplexer for Battery Monitoring Chip

A High Voltage Multiplexer with Rail to Rail Output Swing for Battery Management System Applications

A high EMS daisy-chain SPI interface for battery monitor system

A 40-Mw 7-Bit 2.2-Gs/s Time-Interleaved Subranging ADC for Low-Power Gigabit Wireless Communications in 65-Nm CMOS

A New On-chip Signal Generator for Charge-Based Capacitance Measurement Circuit

A 12-Cell Battery Monitor IC with 2-Channel 16-bit ADCs and Isolated Bidirectional Data Interface

A Multi-Cell Battery Pack Monitoring Chip Based on 0.35-Μm BCD Technology for Electric Vehicles

An Area-Efficient 55 Nm 10-Bit 1-Ms/s Sar Adc for Battery Voltage Measurement

Data Acquisition System for Monomer Battery Based on LTC6803

A 1.27mw 20gbps 1:16 DEMUX with a Symmetrical-Edge-delay Sense Amplifier

Wireless Sensing System-on-Chip for Near-Field Monitoring of Analog and Switch Quantities

A power-efficient acquisition front end for the Li-ion battery management systems

A 20-Gb/s Half-Rate 4:1 Multiplexer with Multiphase Clock Architecture in 40-Nm CMOS Technology

A 64X64-Bit Modified Booth Multiplier Utilizing Multiplexer-Select Booth Encoder

14-Bit 100 Ms/S 121 Mw Pipelined Adc

A 13.56 MHz Multiport-Wireless-Coupled (MWC) Battery Balancer with High Frequency Online Electrochemical Impedance Spectroscopy

A 512 Kb SRAM in 65nm CMOS with Divided Bitline and Novel Two-Stage Sensing Technique

Design of Acquisition Front-end and Σ-ΔADC in Battery Management SoC

Incremental Analog-to-Digital Converter with High Resolution and Low Power for Measurement of Ultra-Low-Frequency Signals