Abstract:Lithium-ion batteries are increasingly common in high-power, safety-critical applications such as aerospace, spaceflight, automotive and grid storage. The voltage and power specifications of such applications usually require large numbers of individual cells combined in series and parallel to form a battery pack. It is then the role of the Battery Management System (BMS) to monitor these cells condition and ensure they remain within safe operating limits. To minimise cost and complexity, it is typical to monitor only a fraction of the cells in a battery pack. This creates potential safety and reliability issues and requires conservative limits imposed on the overall system to ensure safe operation. This is insufficient in high-power, safety-critical applications and thus alternative approaches to battery management are required. Here we demonstrate the development of novel miniature electronic devices for incorporation in-situ at a cell-level during manufacture. This approach enables local cell-to-cell and cell-to-BMS data communication of sensor data without the need for additional wiring infostructure within a battery module assembly. The electronics firmware and hardware integration within the cell's electrode stack is demonstrated to function after triggering post cell formation and through cycling and electrochemical impedance analysis. This work shows that the proposed approach has a negligible impact on the cells' performance and highlights a new technique for active monitoring of the cell's in-situ conditions. This research will enable new methods of cells characterization and monitoring for optimum electrochemical and thermal performance while improving system safety.

A high EMS daisy-chain SPI interface for battery monitor system

A New Battery Management System for Li-Ion Battery Packs

A daisy-chain SPI interface in a battery voltage monitoring IC for electric vehicles

New battery management system for multi-cell li-ion battery packs

A Power Management IC Used for Monitoring and Protection of Li-Ion Battery Packs

Design and implementation of a multifunctional management chip for multi-cell Li-ion batteries in series

Interface Design for Analog Front-End Chips in Battery Management Systems

An area-efficient and high speed multiplexer for battery monitor system

A Battery Monitoring IC with an Isolated Communication Interface for Electric Vehicles

A 12-Cell Battery Monitor IC with 2-Channel 16-bit ADCs and Isolated Bidirectional Data Interface

A Multi-Cell Battery Pack Monitoring Chip Based on 0.35-Μm BCD Technology for Electric Vehicles

A Novel Battery Management System Architecture Based on an Isolated Power/Data Multiplexing Transmission Bus

In-situ electronics and communications for intelligent energy storage

A 13.56 MHz Multiport-Wireless-Coupled (MWC) Battery Balancer with High Frequency Online Electrochemical Impedance Spectroscopy

Data Acquisition System for Monomer Battery Based on LTC6803

Design of Acquisition Front-end and Σ-ΔADC in Battery Management SoC

Bttery management system based on Freescale chip

A Design of Fault-Tolerant Battery Monitoring IC for Electric Vehicles Complying with ISO 26262

An Intelligent Multi- Battery Management System Based on DS2770&CPLD

A High Voltage Multiplexer with Rail to Rail Output Swing for Battery Management System Applications

An Integrated Power Management Unit for a Battery-Operated Wireless Endoscopic System