Abstract:Silicon heterojunction (SHJ) solar cell that combines traditional pure H2 plasma treatments has been frequently reported in the literature. However, this method requires an individual gas blending step between a-Si:H film deposition and post H2 plasma treatment to stabilize the gas environment in the PECVD chamber. Here, we report the introduction of residual SiH4 molecules in H2 plasma to treat SHJ solar cell devices. In contrast to the traditional H2 plasma treatments, it requires no time interval between the a-Si:H film deposition and H2 plasma treatment, i.e., we merely closed the SiH4 inlet after the a-Si:H deposition. In the meantime, all other PECVD parameters were kept unchanged. Taking advantage of the decreasing SiH4 density during the H2 plasma process, a dense silicon layer was grown onto the top layer of the as-deposited a-Si:H film, which inhibited free H atoms effusing out of the low-mass-density a-Si:H network. The better a-Si:H/c-Si interface passivation results in improvements to both the short-circuit current density (Jsc) and open-circuit voltage (Voc) of the SHJ solar cell in comparison to the counterpart cell treated by the traditional pure H2 plasma. For instance, when the n+ a-Si:H window layer is as thin as ~ 1.8nm, the power-conversion efficiency skyrockets from 2.35% treated by the traditional pure H2 plasma to 16.09% treated by the H2 plasma containing residual SiH4 molecules. For a thicker n+ a-Si:H window layer of ~ 4.3nm, the efficiency is also enhanced from 20.66% to 22.74%. This finding paves the way for a more efficient H2 plasma treatment in pursuit of an outstanding SHJ solar cell.

CO2 plasma treatment to promote crystallinity of p-type emitter layer for the silicon heterojunction solar cells

Controllable A-Si:H/c-si Interface Passivation by Residual SiH4 Molecules in H-2 Plasma

Dipoles and Defects Caused by CO2 Plasma Improve Carrier Transport of Silicon Solar Cells

Development of high conducting phosphorous doped nanocrystalline thin silicon films for silicon heterojunction solar cells application

Using phosphorus doped hydrogenated silicon oxycarbide film as a window layer on the light entrance side of silicon heterojunction solar cells: The role of phase separation on electron transport

Role of the Buffer at the Interface of Intrinsic A-Si:H and P-Type A-Si:H on Amorphous/crystalline Silicon Heterojunction Solar Cells

Improving the performance of high-efficiency silicon heterojunction solar cells through low-temperature deposition of an i-a-Si:H anti-epitaxial buffer layer

Impact of Surface Treatments on the Passivation Effect for N-Type Crystalline Silicon in Heterojunction Solar Cells

Improved Amorphous/crystalline Silicon Interface Passivation for Silicon Heterojunction Solar Cells by Hot-Wire Atomic Hydrogen During Doped A-Si:H Deposition

Improved Interface Microstructure Between Crystalline Silicon and Nanocrystalline Silicon Oxide Window Layer of Silicon Heterojunction Solar Cells

Prolonged Annealing Improves Hole Transport of Silicon Heterojunction Solar Cells

Current Injection‐induced Performance Enhancement in n‐type Silicon Heterojunction Solar Cells

Improvement of amorphous silicon n-i-p solar cells by incorporating double-layer hydrogenated nanocrystalline silicon structure

Optimized N-Type Amorphous Silicon Window Layers Via Hydrogen Dilution For Silicon Heterojunction Solar Cells By Catalytic Chemical Vapor Deposition

Synergetic effect of gas compositions on material properties of n‐type nanocrystalline silicon oxide prepared by plasma enhanced chemical vapor deposition

Beyond 25% efficient crystalline silicon heterojunction solar cells with hydrogenated amorphous silicon oxide stacked passivation layers for rear emitter

Enhancing Photovoltaic Effect of Co-2-C-98/Al2o3/Si Heterostructures by Al2o3

Effective Hydrogenation Strategies to Boost Efficiency over 20% for Crystalline Silicon Solar Cell with Al2O3/Cu2O Passivating Contact

Investigation of positive roles of hydrogen plasma treatment for interface passivation based on silicon heterojunction solar cells

Study on P-a-Si:H properties of N-type heterogeneous junction solar cells manufactured by large-area parallel plate PECVD machine

Effective Interface Pretreatment For Amorphous-Crystalline Silicon Heterojunction Solar Cells